Canon PIXMA MX860- Manuals

Preparing Your Multifunction << Previous Next >> Preparing Your Multifunction Note : The procedures below are for Wireless LAN setups not using the WPS (Wi-Fi Protected Setup ) or WCN (Windows Connect Now) setup methods At this point the USB cable should not be connected between the comp...

Preparing Your Multifunction << Previous Next >> 6 Step Three Select Device settings , then press the OK button. Step Four Select LAN settings , then press the OK button.

Preparing Your Multifunction << Previous Next >> 7 Step Seven Press the On button to turn off the printer. Connect the USB cable to the printer and computer Step Five Select Change wireless / wired, then press the OK button. Step Six Select Wireless LAN active , then press the OK button.

Downloading and Installing the Drivers Downloading the Driver To use the machine by connecting it to a computer, software including the drivers needs to be copied (installed) to the computer's hard disk. The installation process takes about 20 minutes. (The installation time varies depending on the ...

Downloading and Installing the Drivers << Previous Next >> 9 Step Three In the Drivers section, click the Download icon for the MP Driver for Network * The file name turns red when the mouse pointer is on the file name.

Downloading and Installing the Drivers << Previous Next >> Step Four On the next screen, read the information and instructions and click I Agree - Begin Download Select [Save] or [Run]. If [Run] is selected, the file will be automatically installed If [Save] is selected, once the file ha...

Step One Click Easy Install . Step Two Click Install . Installing the Driver NOTE: If a User Account Control screen appears, click Continue or Yes (depending on Windows version) to continue. NOTE: If the same screen reappears in subsequent steps, click Continue or Yes . Downloading and Installing th...

Step Four Click Yes on the License Agreement. If the Please Allow All Install Wizard Processes screen appears, click Next . Installation starts. Follow any on-screen instructions to install the software. Step Three Select Use the Printer on network and click Next . Downloading and Installing the Dri...

Step Two When the Printer Connection screen appears, connect the machine to the computer with a USB cable, then turn on the machine. Set up the machine over a USB connection until the network connection is complete. Step One On the Setup Method screen, select Connect printer to the network for the f...

Step Four Detect Access Point. When the Access Points screen appears, select an access point to use, then click Connect. When an access point is detected automatically, the Access Points screen does not appear. Go to step 5. To connect to the access point with WEP or WPA displayed in the Encryption ...

Step Six (Windows XP/2000 Only) When the Network Setup of the Card Slot dialog box appears, specify the drive letter, then click Next . Step Five Detect the Machine When the Set Printer IP Address screen appears, click Connect . If the machine is detected automatically, the Set Printer IP Address sc...

Step Eight Turn off the machine, place the machine in the location where you will use it, and turn it back on again. Step Seven When the Setup Completion dialog box appears, remove the USB cable, then click Next . << Previous Next >> 16 Downloading and Installing the Drivers

Step Ten Confirm the measurement results, then click Finish . Ensure that is displayed in Connection performance between the printer and the access point If any symbol other than is displayed, refer to displayed comments and Help for improving the status of communication link. To check whether the n...

Step Eleven Click Exit. Setup is complete << Previous Next >> 18 Downloading and Installing the Drivers