Avaya SM61 - Manuals - manualsarea.com

Page 2 - Solution & Interoperability Test Lab Application Notes; General Test Approach and Test Results; Interoperability Compliance Testing; XMediusFAX successfully passed compliance testing.

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 2 of 47 Sagemcom_SM61 1. Introduction These Application Notes describe the procedures for configuring Sagem com XMediusFAX Service Provider (SP) Edition with Avaya Aura® Sess...

Page 3 - Reference Configuration; Figure 1; An Avaya S8800 Server running Avaya Aura® Session Manager.

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 3 of 47 Sagemcom_SM61 3. Reference Configuration Figure 1 illustrates the reference configuration used during testing. In the reference configuration, the two sites are conne...

Page 4 - An HP ProLiant DL360 G7 Server running Avaya Aura® Session Manager.

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 4 of 47 Sagemcom_SM61  A Dell™ PowerEdge™ R610 Server running Avaya Aura® System Manager. System Manager provides management functions for Session Manager.  An HP ProLiant ...

Page 5 - Equipment and Software Validated; Equipment

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 5 of 47 Sagemcom_SM61 4. Equipment and Software Validated The following equipment and software were used for the reference configuration: Equipment Software Site 1 Avaya S880...

Page 6 - Configure Communication Manager

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 6 of 47 Sagemcom_SM61 5. Configure Communication Manager This section describes the Communication Manager configuration at Site 2 to support the network shown in Figure 1 . A...

Page 7 - Use the

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 7 of 47 Sagemcom_SM61 Step Description 2. IP network region Use the display ip-network-region command to view the network region settings. The values shown below are the valu...

Page 8 - field to; is suited for networks where packet

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 8 of 47 Sagemcom_SM61 Step Description 3. Codecs IP codec set 1 was used during compliance testing. Multiple codecs can be listed in priority order to allow the codec used by...

Page 9 - Step; Name; column and the IP address; IP address

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 9 of 47 Sagemcom_SM61 Step Description 4. Node Names Use the change node-names ip command to create a node name for the IP address of Session Manager. Enter a descriptive nam...

Page 10 - procr; Far-end Network Region

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 10 of 47 Sagemcom_SM61 Step Description 5. Signaling Group Signaling group 1 was used for the signaling group associated with the SIP trunk group between Communication Manage...

Page 11 - sip; Member Assignment Method:; auto; Signaling Group; This field is set to the signaling group shown in the previous

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 11 of 47 Sagemcom_SM61 Step Description 6. Trunk Group Trunk group 1 was used for the SIP trunk group between Communication Manager and Session Manager. The signaling groups ...

Page 12 - Private Numbering

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 12 of 47 Sagemcom_SM61 Step Description Trunk Group – continued On Page 3 :  The Numbering Format field was set to unk-pvt . This field specifies the format of the calling p...

Page 13 - and are

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 13 of 47 Sagemcom_SM61 Step Description 8. Automatic Alternate Routing Automatic Alternate Routing (AAR) was used to route calls either to Session Manager or to the Communica...

Page 14 - This field is set to the trunk group number defined in

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 14 of 47 Sagemcom_SM61 Step Description 9. Route Pattern Route pattern 1 was used for calls destined for the XMediusFAX fax server through Session Manager. Route patterns 7 a...

Page 15 - Configure Session Manager; – Routing Policies are used in conjunction with a Dial Patterns to

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 15 of 47 Sagemcom_SM61 6. Configure Session Manager This section provides the procedures for configuring Session Manager (version 6.1) as provisioned at Site 2 in the referen...

Page 16 - of the Network Routing Policies specified in the Dial Pattern. The; Login; is the

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 16 of 47 Sagemcom_SM61 example, if a call arrives at Session Manager and matches a certain Dial Pattern, then Session Manager selects one of the Network Routing Policies spec...

Page 17 - The

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 17 of 47 Sagemcom_SM61 2. Add SIP Domain The Routing menu contains all the configuration tasks listed at the beginning of this section. During compliance testing, one SIP Dom...

Page 19 - Add Adaptation; replaces the; Module paramater; replaces the domain in

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 19 of 47 Sagemcom_SM61 4. Add Adaptation An Adaptation was created and applied to the “Fax Server” SIP entity to override the destination domain as shown below. The ingressOv...

Page 20 - Session Manager

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 20 of 47 Sagemcom_SM61 5. Add SIP Entities A SIP Entity must be added for Session Manager and for each SIP-based telephony system supported by it using SIP trunks. During com...

Page 21 - Add SIP Entities (continued) – Session Manager

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 21 of 47 Sagemcom_SM61 Add SIP Entities (continued) – Session Manager The screens below show the SIP Entity configuration details for the Session Manager.

Page 22 - Add SIP Entities (continued) – Communication Manager; CM; Type

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 22 of 47 Sagemcom_SM61 Add SIP Entities (continued) – Communication Manager The screen below shows the SIP Entity configuration details for the Communication Manager. Note th...

Page 23 - Add SIP Entities (continued) – XMediusFax; Other; Adaptation; created

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 23 of 47 Sagemcom_SM61 Add SIP Entities (continued) – XMediusFax The screen below shows the SIP Entity configuration details for the XMediusFAX fax server. Note the Other sel...

Page 24 - TLS

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 24 of 47 Sagemcom_SM61 6. Add Entity Links A SIP trunk between Session Manager and a telephony system is described by an Entity link. Two Entity Links were created: one betwe...

Page 26 - button to add a new Time

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 26 of 47 Sagemcom_SM61 7. Add Time Ranges Before adding routing policies (configured in next step), time ranges must be defined during which the policies will be active. One ...

Page 34 - Configure Sagemcom XMediusFAX; Consult Sagemcom for requirements and instructions.

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 34 of 47 Sagemcom_SM61 7. Configure Sagemcom XMediusFAX This section describes the configuration of XMediusFAX. It assumes that the application and all required software comp...

Page 35 - On the main screen, navigate to

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 35 of 47 Sagemcom_SM61 Step Description 3. Configure Driver Properties On the main screen, navigate to XMediusFAX  System Configuration  Hosts  WIN-8E644SJFMQO  Driver in...

Page 36 - On the

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 36 of 47 Sagemcom_SM61 Step Description 4. General Options On the Driver Properties screen, select the Options tab. Set the Maximum Number Of Channels and Preferred Number Of...

Page 40 - UDP

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 40 of 47 Sagemcom_SM61 Step Description 8. Peer Properties On the Peer Properties screen, configure as follows:  Host Name – Set this field to the IP address of Session Mana...

Page 44 - Once all the driver properties have been configured, go to

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 44 of 47 Sagemcom_SM61 Step Description 12. Once all the driver properties have been configured, go to Start  Control Panel  Administrative Tools  Services to stop and sta...

Page 45 - Send

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 45 of 47 Sagemcom_SM61 Step Description 13. Configure Channels On the main screen, navigate to XMediusFAX  System Configuration  Hosts  WIN-8E644SJFMQO  Driver  Channels...

Page 46 - Verification Steps

MJH; Reviewed: SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes ©2011 Avaya Inc. All Rights Reserved. 46 of 47 Sagemcom_SM61 8. Verification Steps The following steps may be used to verify the configuration:  Using System Manager, navigate to Session Manager  System Status ...