Audiovox AS-9055 - Manual

Audiovox AS-9055

Audiovox AS-9055 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – INSTALLATION OF THE MAJOR COMPONENTS:; PROGRAM SWITCH
  • Page 3 – Starter Output
  • Page 5 – Accessory Output; WIRING CONNECTIONS: 12 Pin Input / Output Harness; Black Wire: Chassis Ground Source; Control Switch; GRAY WIRE: Negative Inhibit Input 1
  • Page 6 – BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2; Brake Switch Positive Shutdown Detail; Switch
  • Page 7 – LIGHT BLUE Wire: Ignition 3 / Shock Disable Output; General Motors VATS By-Pass Diagram
  • Page 8 – DARK GREEN Wire: Tach Sensor Input; Tachometer Input Wiring Detail; Green/Yellow Wire: Diesel Wait To Start Input
  • Page 9 – To program these selectable features:; All applications require that tach be programmed.
  • Page 10 – HOOD PIN SAFETY SHUT DOWN:
  • Page 12 – KEY IN SENSOR CIRCUITS:
  • Page 13 – METHOD 1; METHOD 2
  • Page 14 – COMPLETING THE INSTALLATION:; point these out to the customer.
Loading the manual

128-6832

1 of 16

Kit Contents

(1) - Control Module

(2) - 1 Button High Frequency Transmitters

(1) - 1 Channel Code Learning Receiver

(1) - Multi Pin Input/Output Harness

(1) - Six Pin Power Harness

(1) - Four Pin Accessory Output

(Pulse Before & After Start, During Crank & After Shut Down)

(2) - 30 Amp In-line Fuse Holders With Fuses

(1) - Control Switch

(1) - Programming Switch

(1) - Ring Terminal

(4) - 1/2" Long Screws

(1) - Pin Switch

(1) - Remote Start Warning Label

(1) - Literature Package

Model AS-9055

Installation Manual

Remote Start System

Installation Instructions

This Unit Is Intended For Installation In Vehicles With

12 Volt Negative Ground Electrical Systems,

Gasoline or Diesel With True Tach Reference

And Automatic Transmissions Only.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - INSTALLATION OF THE MAJOR COMPONENTS:; PROGRAM SWITCH

128-6832 2 of 16 This Remote Start System is designed for use with Automatic Transmission Vehicles Only! The unit provides waitto start input for glow plug pre-heat which will be used for all diesel applications. If this wire is not connected, thenthe unit will remain in the Gasoline mode setting, w...

Page 3 - Starter Output

128-6832 3 of 16 3 THE RECEIVER/ANTENNA ASSEMBLY: The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dashboardfor maximum operating range. Choose a location above the belt line (dashboard) of the vehicle for best reception.Special considerations must ...

Page 5 - Accessory Output; WIRING CONNECTIONS: 12 Pin Input / Output Harness; Black Wire: Chassis Ground Source; Control Switch; GRAY WIRE: Negative Inhibit Input 1

128-6832 5 of 16 VIOLET WIRE: Accessory Output Connect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the ignitionswitch is turned to the "ACCESSORY" or "ON" and "RUN" positions and will show 0 volts when the key is turned to the...

Other Audiovox Models