AEG L72670FL- User Manual

4.2 Display A B C D A Temperature area: Temperature indicator Cold water indicator. B Spin area: Spin speed indicator No Spin indicator 1) Rinse Hold indicator 1) Only available for Spin/Drain programme. C Display indicators: Washing phase Rinses phase Spin phase Child safety lock Door lockedYou can...

D Time area: Programme duration Delay start Alarm codes Message of error Programme is completed 5. PROGRAMMES 5.1 Programme Chart ProgrammeTemperaturerange Maximum loadMaximum spinspeed Programme description(Type of load and soil level) Washing programmes Cottons95°C - Cold 7 kg1600 rpm White cotton...

Programme Spin Stain s 1) Extra Rinse 2) Time Save 3) Delay Start Jeans ■ ■ ■ ■ Quick Intensive ■ ■ ■ ■ 20 Min.-3kg ■ ■ Cottons Eco ■ ■ ■ ■ ■ 4) ■ 1) The Stain option is not available with a temperature lower then 40°C. 2) If you set Extra Rinse option, the appliance adds some additional rinses. In ...

Programmes Load (kg) Energy con- sumption(kWh) Water con-sumption(litre) Approxi-mate pro-gramme du-ration (mi-nutes) Remainingmoisture(%) 1) Cottons 60°C 7 1.30 62 157 44 Cottons 40°C 7 0.80 62 154 44 Synthetics 40°C 3,5 0.53 45 127 35 Delicates 40°C 3,5 0.57 53 100 35 Wool/Silk 30°C 2) 1,5 0.25 45...

• After you press Start/Pause : the options and the programme knob are locked. • Before you press Start/Pause : the appliance cannot start. 7.3 Permanent Extra Rinse With this option you can permanently have an extra rinse when you set a new programme. • To activate/deactivate this option press and ...

• The display shows the indicator . To drain the water refer to "Draining water out after end of cycle". 8.8 Temperature Set this option to change the default temperature. Indicator = cold water. The display shows the set temperature. 9. BEFORE FIRST USE 1. Put 2 litre of water in the deterg...

10.3 Filling the detergent and additives Compartment for prewash phase,soak programme or stain remover.Compartment for washing phase.Compartment for liquid additives(fabric conditioner, starch).Maximum level for quantity of liquidadditives.Flap for powder or liquid detergent. Always follow the instr...

• After 5 minutes from the end of the washing programme Press the button On/Off to activate the appliance again. The display shows the end of the last set programme. Turn the programme knob to set a new cycle. If you set a programme or an option that ends with water in the drum, the AUTO Stand-by fu...

• If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness". 11.5 Water hardness If the water hardness in your area is high or moderate, we recomme...

13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The appliance does not start or it stops during operation.First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. With some problems, the acoustic signal...

Problem Possible solution The cycle is longer thanthe time displayed. An unbalanced laundry load increases the duration time. Thisis a normal behaviour of the appliance. The washing results arenot satisfactory. Increase the detergent quantity or use a different detergent. Use special products to rem...

15. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household...