Page 2 - Visit our website for:; Register your product for better service:; CUSTOMER CARE AND SERVICE; General information and tips
CONTENTS 1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 3. TECHNICAL INFORMATION ....
Page 4 - SAFETY INSTRUCTIONS; Installation
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar(0,8 MPa) • The ventilation openings in the base ...
Page 6 - • Disconnect the appliance from the; Service; • Contact the Service to repair the ap-; TECHNICAL INFORMATION
• Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it.• Remove the door catch to prevent children and pets to get closed in theappliance. 2.5 Service • Contact the Service to repair the ap- pliance. We recommend only the useof original spare parts. 3. TECHNICAL I...
Page 7 - PRODUCT DESCRIPTION; Child safety device
4. PRODUCT DESCRIPTION 1 2 3 8 9 5 6 7 4 10 11 12 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Rating plate 6 Drain pump 7 Feet for the appliance level 8 Water drain hose 9 Water inlet valve 10 Mains cable 11 Transit bolts 12 Feet for the appliance level 4.1 Child safety device • ...
Page 8 - On Off button
5. ACCESSORIES 1 2 3 4 1 Spanner To remove the transit bolts. 2 Plastic caps To close the holes on the rear sideof the cabinet after the removal ofthe transit bolts. 3 Anti-flood inlet hose To prevent possible leakage 4 Plastic hose guide To connect the drain hose on theedge of a sink. 6. CONTROL PA...
Page 9 - • After 5 minutes from the end of the; Programme knob; If the programme is completed but the symbol stays on:
• After 5 minutes from the end of the washing programme. Refer to 'At theend of programme'. 6.2 Programme knob 2 Turn this knob to set a programme. Therelated programme indicator comes on. 6.3 Display 3 B A D C The display shows: A • The maximum temperature of the programme. B • The default spin spe...
Page 11 - PROGRAMMES; Functions; WASHING PROGRAMMES
6.10 Spin button 9 Press this button to:• Decrease the maximum speed of the spin phase when you set a pro-gramme. The display shows only the spinspeeds available with the setprogramme. • Deactivate the spin phase.• Activate the 'Rinse Hold' function. Set this function to prevent fabric creases.The a...
Page 15 - CONSUMPTION VALUES; Programme; White Cottons 95°; ration of the; Synthetics 40°; BEFORE FIRST USE; Press button; Loading the laundry; Open the appliance door.
8. CONSUMPTION VALUES Programme Energy con-sumption(KWh) Water con-sumption(litres) Programmeduration(minutes) White Cottons 95° 2.5 76 For the du- ration of the pro- grammes, please refer to the dis- play on the control pan- el. Cottons 60° 1.60 72 Cotton Energy Saving Pro-gramme 60° 1) 1.04 59 Cot...
Page 16 - Filling the detergent and additives; This is the maximum level for the quantity of liquid additives.
Make sure not to put too much laun-dry in the drum. 3. Close the door. Make sure that no laundry stays betweenthe seal and the door. There is a risk ofwater leakage or damage to the laundry. 10.2 Filling the detergent and additives The detergent compartment for the prewash phase, the soakprogramme a...
Page 17 - Check the position of the flap; – Do not use gelatinous or thick; Setting and starting a; The indicator of button
Check the position of the flap 1. Pull out the detergent dispenser un-til it stops. 2. Press the lever down to remove thedispenser. 3. To use powder detergent, turn theflap up. 4. To use liquid detergent, turn theflap down. With the flap in the positionDOWN: – Do not use gelatinous or thick liquid d...
Page 19 - USING THE APPLIANCE - DRYING ONLY; With the; automatic drying; Extra dry symbol; timed drying
• The door lock symbol goes off.• Press button 1 to deactivate the ap- pliance. After five minutes from theend of the programme, the energysaving function automatically deacti-vates the appliance. When you activate the applianceagain, the display show the endof the last set programme. Turnthe progra...
Page 20 - Washing & Automatic drying
The display shows a minimum timevalue. Set time value • Each time you press this button the time value increases by 5 minutes. • After some seconds the time value on the display changes: the appliance cal-culates also the duration of the anti-crease and the cooling phases. Final time value • Press b...
Page 21 - Washing & Timed Drying; Set drying time value; Fluff in the fabrics
The set dryness level sym-bol stays on.The others level symbolsgo off. The door locked symbolcomes on. The display shows the new time valueeach minute. The last minutes of the drying cy-cle the appliance performs theanti-crease and the cooling pha-ses. • When the programme is completed, the applianc...
Page 22 - CLE; HELPFUL HINTS AND TIPS; The laundry load
To remove the fluff inside the drum,set a special programme: • Empty the drum.• Clean the drum, the gasket and the door with a wet cloth. • Set the rinse programme. • Press at the same time button 9 and button 7 to activate the cleaning function until the display shows CLE . • Press button 4 to star...
Page 23 - Drying hints; average; Additional drying
• mmol/l (millimol for each litre - inter- national unit for the hardness of wa-ter). • Clarke degrees. Water hardness table Level Type Water hardness °dH °T.H. mmol/l Clarke 1 soft 0-7 0-15 0-1.5 0-9 2 medium 8-14 16-25 1.6-2.5 10-16 3 hard 15-21 26-37 2.6-3.7 17-25 4 very hard > 21 > 37 >...
Page 24 - CARE AND CLEANING; Descaling; gramme; Door seal; • Clean the drum with special product
14. CARE AND CLEANING WARNING! Disconnect the appliance from the mainssupply before you clean it. 14.1 Descaling The water we use contains limescale. If itbecomes necessary, use a water softenerto remove limescales.Use a special product made for washingmachines. Obey the instructions that youfind on...
Page 25 - Detergent dispenser; To clean the dispenser:; Pull the dispenser out.; Drain pump; • The display shows an alarm code be-
14.6 Detergent dispenser To clean the dispenser: 1 2 1. Press the lever. 2. Pull the dispenser out. 3. Remove the top part of the liquidadditive compartment. 4. Clean all the parts with water. 5. Clean the dispenser recess with abrush. 6. Put back the dispenser in the recess. 14.7 Drain pump Regular...
Page 26 - To clean the drain pump:; Open the drain pump door.
To clean the drain pump: 1. Open the drain pump door. 2. Pull the flap out to remove it. 3. Put a container below the recess ofthe drain pump to collect the waterthat flows out. 4. Press the two levers and pull for-ward the drainage duct to let thewater flow out. 1 2 5. When the container is full of...
Page 27 - • The indicator of button; To clean the water inlet filters:; Emergency drain
1 2 9. Clean the filter under the water tapand put it back in the pump into thespecial guides. 10. Make sure that you tighten correctlythe filter to prevent leakages. 11. Put the flap back and close the drainpump door. 14.8 The inlet hose filter and the valve filter It could be necessary to clean th...
Page 28 - Frost precautions; Remove the water inlet hose; TROUBLESHOOTING; - The appliance does not fill with; Problem; The water tap is closed.
Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the drain system: 1. Put 2 litres of water in the main washcompartment of the detergent dis-penser. 2. Start the programme to drain thewater. 14.10 Frost pre...
Page 31 - • Clean the empty drum, the; INSTALLATION; Fixing plate kit; Available from your authorized dealer.; Unpacking; Remove the cardboard top.
Problem Possible cause Possible solution If there is a big quantityof fluff in the drum re-peat this procedureagain and again: • Clean the empty drum, the gasket and the door with awet cloth. • Set a rinse cycle• Put a wool or piled fabric cloth in the drum. • Set a drying cycle of 10 mi- nutes • Re...
Page 32 - Remove the internal film.
4. Remove the internal film. 5. Open the door. Remove the poly-styrene piece from the door sealand all the items from the drum. 6. Put one of the polystyrene packag-ing elements on the floor behindthe appliance. Carefully put downthe appliance with the rear side onit. Make sure not to damage the ho-...
Page 33 - Pull out the plastic spacers.
9. Remove the power supply cable andthe drain hose from the hose hold-ers. 10. Remove the three bolts. Use the keysupplied with the appliance. 11. Pull out the plastic spacers. 12. Put the plastic caps in the holes.You can find these caps in the usermanual bag. WARNING! Remove all the packaging andt...
Page 35 - • Connect the water inlet hose to the; Water drainage; With the plastic hose guide.
• Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaksfrom the couplings. Do not use an extension hose ifthe inlet hose is too short. Con-tact the service centre for the re-placement of the inlet hose. Water-stop device A The inlet hose has a...
Page 36 - Without the plastic hose guide.; • Directly to a built-in drain pipe in the
• On the edge of a sink.• Make sure that the plastic guide can- not move when the appliance drains.Attach the guide to the water tap orthe wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into adrain pipe at a height of not less than60 cm and not more than 100 cm. Theend o...
Page 37 - ENVIRONMENT CONCERNS
17. ENVIRONMENT CONCERNS Recycle the materials with thesymbol . Put the packaging inapplicable containers to recycle it.Help protect the environment andhuman health and to recycle wasteof electrical and electronic appliances. Do not disposeappliances marked with the symbol with the household waste. ...
