Page 2 - spend a few minutes reading to get the very best from it.; CUSTOMER CARE AND SERVICE; Always use original spare parts.
CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION......................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• The operating water pressure (minimum and maximum) must be between 0.5 (0.05) / 8 (0.8) bar (MPa) • Obey the maximum number of 13 place settings. • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid...
Page 6 - PRODUCT DESCRIPTION
3. PRODUCT DESCRIPTION 4 3 7 9 8 10 5 6 11 1 2 1 Upper spray arm 2 Lower spray arm 3 Filters 4 Rating plate 5 Salt container 6 Air vent 7 Rinse aid dispenser 8 Detergent dispenser 9 Cutlery basket 10 Lower basket 11 Upper basket 3.1 Beam-on-Floor The Beam-on-Floor is a light that is displayed on the...
Page 7 - CONTROL PANEL; Indicators; PROGRAMMES
4. CONTROL PANEL 1 2 9 3 4 5 6 7 8 1 On/off button 2 Display 3 Delay button 4 Programme button (up) 5 Programme button (down) 6 TimeSaver button 7 XtraDry button 8 RESET button 9 Indicators 4.1 Indicators Indicator Description Rinse aid indicator. It is always off while the programme operates. Salt ...
Page 8 - Consumption values; Information for test
Programme Degree of soilType of load Programme phases Options P4 3) • Fresh soil• Crockery and cutlery • Wash 60 °C or 65 °C• Rinses • XtraDry P5 • Normal or light soil • Delicate crock- ery and glass-ware • Wash 45 °C• Rinses• Dry • XtraDry 1) This programme offers the most efficient use of water a...
Page 9 - SETTINGS
6. SETTINGS 6.1 Programme selection mode and user mode When the appliance is in programme selection mode it is possible to set a programme and to enter the user mode. Settings available in the user mode: • The level of water softener according to the water hardness. • Activation or deactivation of t...
Page 11 - OPTIONS; XtraDry
– = Acoustic signal off. – = Acoustic signal on. 2. Press to change the setting. 3. Press on/off to confirm the setting. 6.5 AirDry AirDry improves the drying results with less energy consumption. During the drying phase, the door opens automatically and remains ajar. CAUTION! Do not try to close th...
Page 12 - BEFORE FIRST USE; The salt container
XtraDry is a permanent option for allprogrammes other than and need not to be selected at every cycle.In the other programmes the setting of XtraDry is permanent and it is automatically used in next cycles. This configuration can be changed at any time. Every time is activated, XtraDry is off and ne...
Page 13 - DAILY USE; Using the detergent
6. Turn the cap of the salt container clockwise to close the salt container. CAUTION! Water and salt can come out of the salt container when you fill it. After you fill the salt container, immediately start a programme to prevent corrosion. 8.2 How to fill the rinse aid dispenser A B D C M A X 1 2 3...
Page 15 - HINTS AND TIPS
Cancelling the programme Press and hold RESET until the appliance is in programme selection mode. Make sure that there is detergent in the detergent dispenser before you start a new programme. End of the programme When the programme is completed the display shows 0:00. All buttons are inactive excep...
Page 16 - CARE AND CLEANING; Cleaning the filters
• Do not put in the appliance items made of wood, horn, aluminium, pewter and copper. • Do not put in the appliance items that can absorb water (sponges, household cloths). • Remove remaining food from the items. • Make soft the remaining burned food on the items. • Put hollow items (cups, glasses a...
Page 18 - TROUBLESHOOTING
• If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month. • To maintain the performance of your appliance at its best, we recommend to use monthly ...
Page 19 - The washing and drying results are not satisfactory
Problem and alarm code Possible cause and solution The appliance stops andstarts more times during op-eration. • It is normal. It provides optimal cleaning results and en- ergy savings. The program lasts too long. • Select the TimeSaver option to shorten the program time. • If the delayed start opti...
Page 21 - PRODUCT INFORMATION SHEET
Problem Possible cause and solution Limescale deposits on the ta-bleware, on the tub and onthe inside of the door. • The level of salt is low, check the refill indicator.• The cap of the salt container is loose.• Your tap water is hard. Refer to "The water softener" . • Even using multi-func...
Page 22 - ADDITIONAL TECHNICAL INFORMATION; SAUDI ARABIA - CUSTOMER SERVICE
The ‘standard programme’ is the standard cleaning cycle to whichthe information in the label and the fiche relates. This programme issuitable to clean normally soiled tableware and is the most efficientprogramme in terms of combined energy and water consumption. Itis indicated as "Eco" progr...
Page 23 - ENVIRONMENTAL CONCERNS
16. ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol with the household wast...
