Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION; Before the installation and use of the appliance,
CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION......................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. • Do not leave the appliance with the door open, to avoid a tripping hazard. • Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket. ...
Page 6 - PRODUCT DESCRIPTION
3. PRODUCT DESCRIPTION 6 5 8 10 9 7 11 12 3 4 2 1 1 Worktop 2 Top spray arm 3 Upper spray arm 4 Lower spray arm 5 Filters 6 Rating plate 7 Air vent 8 Rinse aid dispenser 9 Detergent dispenser 10 Lower basket 11 Upper basket 12 Cutlery drawer 3.1 Beam-on-Floor The Beam-on-Floor is a light that is dis...
Page 7 - CONTROL PANEL; Indicators; PROGRAMMES
4. CONTROL PANEL 1 2 3 4 5 6 7 8 9 1 On/off button 2 Display 3 Program button 4 Delay button 5 MyFavourite button 6 TimeSaver button 7 XtraDry button 8 ExtraHygiene button 9 Indicators 4.1 Indicators Indicator Description Rinse aid indicator. It is on when the rinse aid dispenser needs refilling. 5....
Page 8 - Consumption values
Programme Degree of soilType of load Programme phases Options P5 4) • Normal or light soil • Delicate crock- ery and glass-ware • Wash 45 °C• Rinses• Dry • XtraDry P4 5) • Fresh soil• Crockery and cutlery • Wash 60 °C• Rinses • ExtraHygiene• XtraDry P7 6) • All • Prewash P6 7) • Normal soil• Crocker...
Page 9 - SETTINGS
Programme 1) Water (l) Energy (kWh) Duration (min) P4 10.5 0.9 38 P7 4.0 0.01 14 P6 9.0 - 10 1.1 - 1.3 230 - 250 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.2 Information for test institutes To ...
Page 11 - OPTIONS
During the drying phase, the door opens automatically and remains ajar. CAUTION! Do not try to close the appliance door within 2 minutes after automatic opening. This can cause damage to the appliance. If, afterwards, the door is closed for another 3 minutes, the running programme ends. AirDry is au...
Page 12 - BEFORE FIRST USE
XtraDry is a permanent option for allprogrammes other than . It is automatically activated in next cycles. This configuration can be changed at any time. Every time is activated, XtraDry is off and needs to be chosen manually. Activating XtraDry deactivates TimeSaver and vice versa. How to activate ...
Page 13 - DAILY USE; Using the detergent
CAUTION! Only use rinse aid designed specifically for dishwashers. 1. Open the lid ( C ). 2. Fill the dispenser ( B ) until the rinse aid reaches the marking ''MAX''. 3. Remove the spilled rinse aid with an absorbent cloth to prevent excessive foam formation. 4. Close the lid. Make sure that the lid...
Page 14 - HINTS AND TIPS
5. Close the appliance door to start the programme. Starting a programme with delay start 1. Set a programme. 2. Press repeatedly until the display shows the desired delay time (from 1 to 24 hours). The indicator is on. 3. Close the appliance door to start the countdown. During the countdown, it is ...
Page 15 - CARE AND CLEANING
10.2 Using rinse aid and detergent • Only use rinse aid and detergent for dishwasher. Other products can cause damage to the appliance. • Detergent tablets do not fully dissolve with short programs. To prevent detergent residues on the tableware, we recommend that you use the tablets with long progr...
Page 17 - TROUBLESHOOTING
11.2 Cleaning the upper spray arm We recommend to clean the upper spray arm regularly to prevent soil from clogging the holes.Clogged holes can cause unsatisfactory washing results. 1. Pull out the upper basket. 2. To detach the spray arm from the basket, press the spray arm upwards and simultaneous...
Page 19 - The washing and drying results are not satisfactory
Problem and alarm code Possible solution The appliance door is diffi-cult to close. • The appliance is not levelled. Loosen or tighten the ad- justable feet (if applicable). • Parts of the tableware are protruding from the baskets. Rattling/knocking soundsfrom inside the appliance. • The tableware i...
Page 20 - TECHNICAL INFORMATION
Problem Possible cause and solution The dishes are wet. • For the best drying performance activate the option XtraDry and set AirDry . • The programme does not have a drying phase or has a drying phase with low temperature. • The rinse aid dispenser is empty.• The quality of the rinse aid can be the...
Page 21 - INSTALLATION; Fitting under a counter
Electrical connection 1) Voltage (V) 200 - 240 Frequency (Hz) 50 / 60 Wattage (W) 1550-2200 Water supply pressure bar (minimum and maximum) 0.5 - 8 kPa (minimum and maximum) 50 - 800 Water supply Cold water or hot water 2) max 60 °C Capacity Place settings 15 1) Refer to the rating plate for other v...
Page 22 - Water drain hose; WARRANTY
Adjusting the level of the appliance A correct adjustment of the level of the appliance allows the door to close and seal correctly.If the door does not close correctly, loosen or tighten the adjustable feet to level the appliance. 14.2 Water connection Water inlet hose Connect the inlet hose to a w...
Page 25 - ENVIRONMENTAL CONCERNS
FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL [email protected] For the cost of a local call (Australia only) FOR SPARE PARTS or to find the address of your nearest spare parts centre in Australia PLEASE CALL 13 ...
