Page 3 - CONTENTS; programme
CONTENTS 4 Safety information7 Product description8 Control panel 10 Use of the appliance10 Setting the water softener12 Use of dishwasher salt12 Use of detergent and rinse aid13 Loading cutlery and dishes16 Washing programmes17 Setting and starting a washing programme 18 Care and cleaning20 What to...
Page 4 - Children and vulnerable persons safety; fall on an open door.; Use; vent injury to persons and damage to property.
SAFETY INFORMATION Before the installation and use, read this manual carefully:• For your safety and the safety of your property.• To help the environment.• For the correct operation of the appliance.Always keep these instructions with the appliance also if you move or give it to a differentperson.T...
Page 5 - Care and cleaning; damage to the appliance.; Installation; and electrical components.; Frost precautions; water flow for some minutes, then connect the inlet hose.
• Fill the appliance with salt before you start a washing programme. Remaining salt in the appliance can cause corrosion or make a hole in the bottom of the appliance. • Do not fill the rinse aid dispenser with other products than the rinse aid, (dishwasher cleaning agent, liquid detergent). This ca...
Page 6 - Electrical connection; Only for UK and Ireland; Service centre; Safety information
• Make sure not to squash or cause damage to the water hoses when you install the appli- ance. • Make sure that the water couplings are tight to prevent a water leakage.• The first time you use the appliance, make sure that the hoses do not have water leaks.• The water inlet hose has a safety valve ...
Page 7 - To discard the appliance; The dishwasher detergents are dangerous and can cause corrosion !; PRODUCT DESCRIPTION
To discard the appliance • To prevent the risk of injury or damage: – Disconnect the mains plug from the mains socket.– Cut off the mains cable and discard it.– Remove the door catch. This prevents children or pets to be closed in the appliance. There is a risk of suffocation. – Discard the applianc...
Page 8 - CONTROL PANEL; Programme selection/cancel button
6 Rating plate 7 Filters 8 Lower spray arm 9 Upper spray arm CONTROL PANEL 2 1 3 4 5 B A 1 On/off button 2 Programme indicator lights 3 Indicator lights 4 Programme button 5 Delay start button Indicator lights End-of-programme The indicator comes on when: • The washing programme is completed. • You ...
Page 9 - The appliance must be in setting mode for these operations:; Audible signals; Switch on the appliance.
• To set the water softener. Refer to the chapter 'Setting the water softener'.• To deactivate/activate the audible signals. Refer to the section 'Audible signals'.• To cancel a washing programme in progress. Refer to the chapter 'Setting and starting a washing programme'. Delay start button Use thi...
Page 11 - You must adjust the water softener manually and electronically.; Manual adjustment
Water hardness Water hardness ad- justment German degrees (°dH) French degrees (TH°) mmol/l Clarke de- grees manually elec- tronical- ly 19 - 22 33 - 39 3,3 - 3,9 23 - 27 2 1) 5 1) 15 - 18 26 - 32 2,6 - 3,2 18 - 22 1 4 11 - 14 19 - 25 1,9 - 2,5 13 - 17 1 3 4 - 10 7 - 18 0,7 - 1,8 5 - 12 1 2 < 4 &...
Page 12 - USE OF DISHWASHER SALT; How to fill the salt container; USE OF DETERGENT AND RINSE AID; Use of detergent
USE OF DISHWASHER SALT How to fill the salt container 1. Turn the cap counterclockwise and open the salt container. 2. Fill the salt container with 1 litre of water (only for the first time you fill with salt). 3. Use the funnel to fill the salt container with salt. 4. Remove the salt around the ope...
Page 13 - LOADING CUTLERY AND DISHES; Hints and tips
5. Close the detergent dispenser. Press the lid until it locks into position. Different brands of detergent dissolve in different times. Some detergent tablets do nothave the best cleaning results during short washing programmes. Use long washing pro-grammes when you use the detergent tablets to ful...
Page 14 - Put the forks and spoons with the handles down.
• Remove the remaining food from the items.• Make soft the remaining burned food on the items.• Put hollow items (cups, glasses and pans) with the opening down.• Make sure that water does not collect in containers or in bowls.• Make sure that cutlery and dishes do not bond together.• Make sure that ...
Page 15 - Adjust the height before you load the upper basket.
Put the knives with the handles up.Mix the spoons with other cutlery to prevent themto bond together.Use the cutlery grid. If the dimensions of the cut-lery prevent use of the cutlery grid, you can easilyremove it. Upper basket The upper basket is for plates (maximum 24 cm indiameter), saucers, sala...
Page 16 - Put the basket in the upper position.; WASHING PROGRAMMES; Washing programmes
Maximum height of the dishes in: the upper basket the lower basket Higher position 20 cm 31 cm Lower position 24 cm 27 cm Do these steps to move the upper basket to the higher position:1. Move the front runner stops (A) out. 2. Pull the basket out. 3. Put the basket in the upper position. 4. Put bac...
Page 17 - SETTING AND STARTING A WASHING PROGRAMME; Select and start a washing programme without delay
Consumption values Programme Programme time (mi- nute) Energy (kWh) Water (litre) 120-130 1,8-2,0 22-24 100-110 1,4-1,6 19-21 130-140 1,0-1,2 14-16 12 0,1 5 The water pressure and temperature, the variations of the mains supply and the quantity ofdishes can change the consumption values. SETTING AND...
Page 18 - CARE AND CLEANING; To remove and clean the filters
How to cancel a washing programme or a delay start If a washing programme or a delay start has not started, you can change the selection.When a washing programme or a delay start are in progress, it is not possible to change theselection. It is necessary to cancel the washing programme or a delay st...
Page 20 - WHAT TO DO IF...; What to do if...
WHAT TO DO IF… The appliance does not start or stops during operation.First try to find a solution to the problem (refer to the chart). If not, contact the servicecentre. Malfunction Fault code Possible cause Possible solution The appliancedoes not fillwith water. • The light of the pro- gramme in p...
Page 21 - The washing results and drying results are not satisfactory
Malfunction Fault code Possible cause Possible solution The mains plug is notconnected in. Put in the mains plug. Blow out fuse in thehousehold fuse box. Replace the fuse. The delay start is set. If you want to cancelthe delay start, refer to'Select and start awashing programme'. After the check, sw...
Page 22 - TECHNICAL DATA; The symbol
Problem Possible cause Possible solution There are streaks, milky stains,or a bluish layer on glasses anddishes. Rinse aid dosage is too high. Decrease the rinse aid dosage. Dry water drop stains onglasses and dishes. Rinse aid dosage is too low. Increase the rinse aid dosage. The detergent can be t...
Page 23 - ance and endanger their lives.
The packaging materials are environmentally friendly and can be recycled. The plastic com-ponents are identified by markings, e.g. >PE<, >PS<, etc. Discard the packaging materials inthe applicable container at the community waste disposal facilities. WARNING! To discard the appliance, fo...
