Zanussi ZDT26030FA- User Manual

Page 3 - SAFETY INSTRUCTIONS

• Put the cutlery in the cutlery basket with the sharp ends pointing down or put them in the cutlery drawer in a horizontal position with the sharp edges down. • Do not leave the appliance with the open door unattended to avoid stepping accidentally onto it. • Before any maintenance operation, deact...

Page 5 - EASY START; PROGRAMMES

EASY START 1 3 4 5 6 7 8 9 2 1 On/off button 2 Display 3 Programme button (up) 4 Programme button (down) 5 TimeManager button 6 XtraDry button 7 Delay button 8 CANCEL button 9 Indicators INDICATORS End indicator.Salt indicator. It is always off while the programme operates.Rinse aid indicator. It is...

Page 6 - SETTINGS

Programme Degree of soil Type of load Programme phases Consumption values 1) Duration (min) Energy (kWh) Water (l) P2AUTOMATIC 3) All Crockery, cut- lery, pots and pans • Pre-wash • Wash from 45 °C to 70 °C • Rinses • Dry 45 - 160 0.7 - 1.5 7 - 12 P3 Intensive Heavy soil Crockery, cut- lery, pots an...

Page 8 - BEFORE FIRST USE

DEACTIVATING THE RINSE AID EMPTY NOTIFICATIONMake sure the appliance is in user mode.1. Press . • The indicators , and are off. • The indicator still flashes. • The display shows the current setting: – = rinse aid empty notification activated. – = rinse aid empty notification deactivated. 2. Press t...

Page 9 - DAILY USE

The salt is used to recharge the resin in the water softener and to assure good washing results in daily use. Adding salt Before the first use, put one litre of water in the salt container. CAUTION! Water and salt can come out of the salt container during filling. To prevent corrosion, start a progr...

Page 11 - HINTS AND TIPS

If the option is not applicable to the programme, the related indicator does not turn on or it flashes quickly for a few seconds and then turns off. Opening the door while the appliance operatesOpening the door while a programme is running stops the appliance. It may affect the energy consumption an...

Page 12 - CARE AND CLEANING

WHAT TO DO IF YOU WANT TO STOP USING MULTI-TABLETSBefore you start to use separately detergent, salt and rinse aid do the following procedure.1. Set the highest level of the water softener. 2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rinsing p...

Page 13 - TROUBLESHOOTING

C • Make sure that there are no residues of food or soil in or around the edge of the sump. • Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides. • Reassemble the filters (A) and (B). • Put back the filter (A) in the flat filter (C). Turn it clockwise...

Page 16 - TECHNICAL INFORMATION

Problem Possible cause and solution There are residues of detergent in the dispenser at the end of the programme. • The detergent tablet got stuck in the dispenser and therefore was not completely washed away by water. • Water cannot wash away the detergent from the dispenser. Make sure that the spr...

Page 17 - ENVIRONMENTAL CONCERNS

RATING PLATE Mod. ... ... ...Prod. No. ... ... ... Ser. No. ... INFORMATION FOR TEST INSTITUTESFor all the necessary information for test performance, send an email to:[email protected]Write down the product number (PNC) that is on the rating plate. ENVIRONMENTAL CONCERNS Recycle the materials with ...

Zanussi ZDT26030FA- User Manual

Table of Contents:

Summary

Other Zanussi Models