York 2000 - Manual
York 2000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FIGURES; No. Description Page; TABLE OF CONTENTS
- Page 3 – INSTALLATION
- Page 4 – Unitary Products Group
- Page 6 – OPTIONAL ECONOMIZER RAIN HOOD; NOTE: Sensor must be positioned so that the sensing ports
- Page 7 – TABLE 3 - PHYSICAL DATA
- Page 11 – TABLE 10 - ELECTRICAL DATA
- Page 12 – NOTE: Prior to each cooling season, the crankcase heater; COOLING SEQUENCE OF OPERATION; CONTROL; OPERATION
- Page 13 – LOCKOUT CONTROL; NOTE: Models with an anti-recycle accessory will have a; CHECKING SUPPLY AIR CFM; NOTE: The tubes must be inserted and held in a position; TURNS
- Page 14 – NORMAL MAINTENANCE; CAUTION: Prior to any of the following maintenance proce-; MAINTENANCE; FIG. 10 - PRESSURE DROP ACROSS A DRY INDOOR; COIL VS. SUPPLY AIR CFM
GENERAL
YORK Model BCH units are single package heat pumps
designed for outdoor installation on a rooftop or a slab.
Supplemental electric heaters are available as field-installed
accessories.
The units are completely assembled on rigid, permanently
attached base rails. All piping, refrigerant charge, and electrical
wiring is factory-installed and tested. The units require only
electric power and duct connections at the point of installation.
The supplemental elec tr ic heaters have nickel-chrome
elements and utilize single point power connection.
INSPECTION
As soon as a unit is received, it should be inspected for possible
damage during transit. If damage is evident, the extent of the
damage should be noted on the carrier’s freight bill. A separate
request for inspection by the carrier’s agent should be made in
writing. Refer to Form 50.15-NM for additional information.
REFERENCE
Additional information on the design, installation, operation and
service of this equipment is available in the following reference
forms:
•
55.70-N1 -General Installation
•
55.70-N2 -Pre-start & Post-start Check List
•
530.18-N1.2V -Economizer Accessory
•
530.18-N1.13V -Man. Outdoor Air Damper Accy 0-35%
•
530.18-N1.14V -Man. Outdoor Air Damper Accy 0-100%
•
530.18-N1.12V -Motorized Outdoor Air Damper Accy.
•
530.18-N7.1V -Electric Heater Accessory
•
530.18-N7.2V -Fuse Block Accessory
Replacement Parts:
•
Refer to Par ts Manual for complete listing of replacement
parts on this equipment.
All forms referenced in this instruction may be ordered from:
Standard Register
Norman, OK 73069
Toll Free: Tel. 877-318-9675/Fax. 877-379-7920
APPROVALS
Design cer tified by U.L. and C.G.A. as follows:
1. For use as a heat pump only unit or a heat pump unit with
supplemental electric heat.
2. For outdoor installation only.
3. For installation on combustible material.
LIMITATIONS
®
SUNLINE 2000
SINGLE PACKAGE HEAT PUMPS
INSTALLATION INSTRUCTION
Supersedes: 511.06-N5Y (1298)
511.06-N5Y (500)
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make
the installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury
and/or equipment damage may result if installation procedure is not handled properly.
035-16197
MODELS B*CH 036 AND 048 (STYLE B)
AND MODELS B*CH 060A (STYLE A)
(10 SEER - w/Belt-Drive Option)
(* = 3 or 5)
CAUTION
T H E E N C LO SE D IN S TA LLA TIO N IN S TR U C TIO N S A N D A N Y A P PLIC A B LE
LO C AL, ST AT E, A N D N AT IO N A L C O D E S IN C LU D IN G , B U T N O T LIM IT ED
TO , BU ILD IN G , ELE C TR IC A L, AN D M E C H AN IC A L C O D E S .
T H IS P R O D U C T M U S T B E IN S T A L L E D IN S T R IC T C O M P LIA N C E W IT H
WARNING
O P E R A T IO N O F T H E P R O D U C T C O U L D C A U S E P E R S O N A L IN J U R Y
O R P R O P E R T Y D A M A G E .
IN C O R R E C T IN S TA LLAT IO N M AY C R E A TE A C O N D IT IO N W H E R E TH E
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
General ................................................................................ 1Inspection............................................................................. 1Reference............................................................................. 1Approvals ..........................
These units must be installed in accordance with the currentedition of the following national and local safety codes: In U.S.A.: 1. National Electrical Code ANSI/NFPA No. 70. 2. Local electric utility requirements. In Canada: 1. Canadian Electrical Code C22.1 2. Canadian Installation Codes CAN/CGA-B...
casing. Outdoor ductwork must be insulated and water- proofed. Refer to Figure 6 for information concerning side and bottomsupply and return air duct openings. FILTERS 1" filters are supplied with each unit. 2" replacement filters maybe used with no modification to the filter racks. Filters ...
