Wayne Dalton 8700 - Manual
Wayne Dalton 8700 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Parts Breakdown
- Page 3 – Important Safety Instructions; WARNINg; Tools Required
- Page 4 – Door Section Identification; Removing an Existing Door; A POWERFuL SPRINg RELEASINg ITS ENERgy SuDDENLy CAN CAuSE SEvERE; Preparing the Opening
- Page 6 – InstallatIon; Fully Adjustable Flag Angles; FAILuRE TO ENSuRE TIgHT FIT OF CABLE LOOP OvER MILFORD PIN COuLD
- Page 7 – Top Fixtures
- Page 8 – Lift Handle; TO AvOID POSSIBLE INJuRy, LIFT HANDLES THAT ARE INSTALLED WITHIN; Bottom Section
- Page 9 – Top Section; Drawbar Operator Bracket
- Page 10 – End Bearing Brackets
- Page 11 – Torsion Spring Assembly; Torsion Spring Attachment; Counterbalance Lift Cables
- Page 12 – Winding Springs
- Page 13 – Rear Back Hangs
- Page 14 – Label Placement
- Page 15 – Inside Lock; Pull Down Rope; DO NOT INSTALL PuLL DOWN ROPE ON DOORS WITH OPERATORS. CHILDREN; Door Arm Hookup; optional Installation
- Page 16 – Maintenance
- Page 17 – Limited Warranty; uNDERSCORED BOLD FACE TyPE; warranty
- Page 18 – Please Do Not Return This Product To The Store; thank you for your purchase.; Find a Dealer; section online at
GARAGE DOORS & OPENERS
Part No.
IMPORTANT NOTICES!
Wayne-Dalton highly recommends that you read and fully under-
stand the Installation Instructions and Owner’s Manual before you
attempt this installation.
To avoid possible injury, read the enclosed instructions carefully
before installing and operating the garage door. Pay close attention
to all warnings and notes. After installation is complete, fasten this
manual near garage door for easy reference.
The complete Installation Instructions and Owner’s Manual are
available at no charge from:
Wayne-Dalton, a Division Of Overhead Door Corporation,
P.O. Box 67, Mt. Hope, OH., 44660,
Or Online At
www.Wayne-Dalton.com
F
ront
M
ount
L
ow
H
eadrooM
I
n s I d e
H
o o k
- u
p
MH
InstaLLatIon
InstructIons
and
owner
’
s
ManuaL
t
o r s I o n
8700
T a b l e O f C o n t e n t s
347215
REV1 08/22/2011
©Copyright 2011 Wayne-Dalton, a Division Of Overhead Door Corporation
Parts Breakdown
2
Pre-Installation
3
Important Safety Instructions
3
Tools Required
3
Package Contents
3
Door Section Identification
4
Removing an Existing Door
4
Preparing the Opening
4
Installation
6
Optional Installation
15
Inside Lock
15
Pull Down Rope
15
Door Arm Hookup
15
Maintenance
16
Cleaning Your Garage Door
16
Operation and Maintenance
16
Warranty
17
Dealer Locator Information
18
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com A. FLAg ANgLES (AS REquIRED): A1. Fully Adjustable (F...
Important Safety Instructions DEFINITION OF kEy WORDS uSED IN THIS MANuAL: WARNINg WARNINg INDICATES A POTENTIALLy HAzARDOuS SITuATION WHICH; IF NOT AvOIDED, COuLD RESuLT IN SEvERE OR FATAL INJuRy. CAuTION: PROPERTY DAMAGE OR INJURY CAN RESULT FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORTANT: REQUIRED...
Cable drums RH/LH Center bracket bushing Torsion springs RH/LH End bearing brackets RH/LH Counterbalance lift cables (2) 5/16”-18 Hex nuts (2) 3/8”- 16 Hex nuts 1/4”- 20 Flanged hex nuts (as required) (2) 1/4” - 20 Hex nuts (lift handles) (2) 3/8”-16 x 3/4” Truss head bolts 5/16”-18 Flange hex nuts ...
