Wayne Dalton 8850 - Manual
Wayne Dalton 8850 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Please Do Not Return This Product To The Store.; Find a Dealer; ReaD aND Follow all iNSTallaTioN iNSTRucTioNS.; after installation is complete, fasten this manual; Table of Contents; INDICATES A POTENTIALLY hAzARDOUS; PROPERTY DAMAGE OR INjURY CAN RESULT; waRNiNg
- Page 3 – Package contents
- Page 4 – ToP SecTioN; Door Section identification
- Page 5 – Tools Required
- Page 6 – Preparing the opening; Recommended; heaDRoom RequiRemeNT:
- Page 7 – PR; installation; INSTALLING PRODUCTS ON UN-TREATED LUMBER.; consult your Wayne-Dalton representative.
- Page 8 – attaching counterbalance cables; ”/3” bottom brackets with Roller carriers:; bottom bracket
- Page 9 – iNST; Stack the bottom section into position by; NoTe; : Adjust the spacing of the vertical
- Page 10 – attaching continuous wall angle &; hinges; eNDhiNge chaRT
- Page 12 – Top bracket; bottom section
- Page 14 – adjusting Top brackets; DO NOT RAISE DOOR UNTIL hORIzONTAL
- Page 15 – Torsion end bearing brackets
- Page 16 – Torsion Spring assembly
- Page 18 – counterbalance cables; fAILURE TO PLACE VICE CLAMPS
- Page 20 – Rear Support
- Page 22 – Side lock; Power Drill; Pull Rope; After completing this step, continue; DO NOT INSTALL PULL ROPES
- Page 23 – Trolley operator; Tape Measure
- Page 24 – Exhaust port is installed on the back side of; exhaust Port installation
- Page 25 – mai; DO NOT USE A PRESSURE WAShER ON YOUR GARAGE DOOR!; The following cleaning solution is recommended; NEVER MIX CLEANSERS OR DETERGENTS WITh BLEACh.; glaSS cleaNiNg iNSTRucTioNS
- Page 26 – limited warranty; uNDeRScoReD bolD Face TyPe
- Page 27 – Please Do Not Return This Product To The Store
8850 Aluminum Full View
IMPORTANT NOTICE!
Read these instructions carefully before
attempting installation. If in question about
any of the procedures, do not perform the
work. Instead, have a qualified door agency
do the installation or repairs.
© Copyright 2009 Wayne-Dalton Corp.
Part No. 348366
REV1 08/03/2009
Torsion Spring
Installation Instructions and Owner’s Manual
Wayne-Dalton Corp.
P.O. Box 67
Mt. Hope, OH 44660
www.wayne-dalton.com
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com ReaD TheSe iNSTRucTioNS caReFully beFoRe aTTemPTiNg i...
3 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com Package contents (1) TORSION TUBE NoTe: DEPENDING ON ...
4 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com Tools Needed: Package contents continued... (2) 1/4”-...
