Timberk T-GS4-G10 - User Manual

Page 7 - Рисунок 1; Присоедините два колеса; Рисунок 2

IM2022 7 Рисунок 1 2. Присоедините два колеса ко дну лицевой панели прибора (6). Присоедините два других колеса к нижней панели (10) с помощью двух гаек . Используйте 4 болта 5*8 мм для присоединения нижней панели (10) к левой и правой стенкам (см. рисунок 2) Рисунок 2

Page 10 - Аккуратно извлеките обогреватель из упаковки.; НИКОГДА НЕ ИСПОЛЬЗУЙТЕ СПИЧКИ, ЗАЖИГАЛКИ И ДРУГИЕ; Используйте мыльную воду.

IM2022 10 8. УСТАНОВКА Минимальные расстояния до ближайших поверхностей: (вид сверху) Рисунок 7 Подготовка к работе 1. Аккуратно извлеките обогреватель из упаковки. 2. Убедитесь, что на керамической газовой горелке и других частях прибора не осталось крошки упаковочного пенопласта или другого мусора...

Page 15 - while it is operating. Do not dry clothes or any other

IM2022 15 Dear customer! We thank you for your wise choice and for a purchase of a gas heater. It will serve you for a long time. 1. IMPORTANT INFORMATION Please, read this manual before using the device. This manual contains important information regarding your safety, as well as recommendations co...

Page 18 - DELIVERY SET; Flame regulator knob

IM2022 18 Fig. 3* Fig. 4* Fig. 1* *The appearance of the device may differ from the images in the manual 1. Left side panel 2. Top panel 3. Right side panel 4. Bottom panel 5. Top panel 6. Front panel 7. Gas cylinder holder 8. Left side panel 9. Right side panel 10. Bottom panel 11. Control panel 12...

Page 19 - ASSEMBLING THE DEVICE; Use 6 screws 4*8 mm

IM2022 19 7. ASSEMBLING THE DEVICE Please see the contents of the sections "Device description" and "Delivery set" before assembling the device Unpack the device and the assembling kit, prepare the necessary tools for assembling the device 1. Lay the front panel of the device on the ...

Page 21 - Install the plastic flame regulator knob on the gas valve (see fig. 5)

IM2022 21 4. Attach the top panel (5) to the left and right sides with 8 x 4*8 mm screws (see fig. 4) Fig. 4 5. Install the plastic flame regulator knob on the gas valve (see fig. 5) Fig. 5

Page 22 - INSTALLATION

IM2022 22 6. Install the gas container holder on the left and right sides after installing the gas container on the bottom panel of the device (see fig. 6) Fig. 6 8. INSTALLATION Minimal distances from other surfaces: (view from above) Fig. 7

Page 23 - • Do not use the heater while sleeping.; Installation of the cylinder is prohibited:

IM2022 23 Beginning 1. Carefully remove the device from its packaging. 2. Ensure that there is no crumble of polystyrene foam or other debris remaining on the ceramic gas burner and other parts of the appliance. 3. Install the paronite / rubber gasket inside the union nut, making sure that it is int...

Page 25 - Ignition burner does not ignite

IM2022 25 3. If you do not plan to use the heater in the near future, disconnect the gas cylinder from the gas reducer. Take the gas cylinder to the storage place in accordance with the recommendations and requirements described in this manual. Gas cylinder replacement 1. Make sure the heater is tur...

Timberk T-GS4-G10 - User Manual

Table of Contents:

Summary

Other Timberk Heaters Models