Thermo Pride GMC-85 - Manual
Thermo Pride GMC-85 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – causing personal injury, loss of life or property damage.
- Page 8 – This furnace is not to be used as a construction heater.; Combustible material:
- Page 9 – CLOSET ALCOVE
- Page 10 – III. FURNACE SPECIFICATIONS; HEATING
- Page 11 – P265 FEP; BLOWER DATA
- Page 12 – must comply with the requirements of this manual.
- Page 14 – D. BASE INSTALLATION; IMPORTANT
- Page 15 – COMBUSTION AIR; for further details regarding combustion air requirements.
- Page 17 – must; be provided to the front of the
- Page 22 – Do not run the oil pump dry for more than five minutes.; Avoid running tubing against any type of
- Page 26 – wires to the thermostat.
- Page 27 – WIRING DIAGRAM
- Page 31 – BURNER COMBUSTION PARAMETERS
- Page 32 – V. DEALER MAINTENANCE
- Page 33 – OMC/GMC TROUBLESHOOTING FLOWCHART
- Page 39 – C. HEAT EXCHANGER CLEANING INSTRUCTIONS; The heat exchanger must be cleaned by a qualified service person.
- Page 41 – be cleaned or replaced; be replaced
- Page 42 – VI. USER INFORMATION SECTION; tossing burning papers or other material into the furnace.
THERMO
PRODUCTS,
LLC.
POST OFFICE BOX 217
NORTH
JUDSON,
IN
46366
PHONE: (574) 896-2133
MO-422
ECN 4528-MA
MADE IN USA
GAS-FIRED OR OIL-FIRED FURNACE
DOWN FLOW & DIRECT VENT (SEALED COMBUSTION)
MODELS: OMC-70 AND GMC-85
INSTALLATION AND SERVICE MANUAL
For installation in:
1. Manufactured Homes
2. Modular Homes/Buildings
3. Site Construction—Residential (Single Story Dwellings)
:
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or
any other appliance.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
:
If the information in these instructions is not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
:
Improper installation, adjustment, alteration, service, or maintenance can cause injury or property
damage. Refer to this manual. For assistance or additional information consult a qualified installer, service
agency, or fuel supplier.
:
Do not use this appliance if any part has been underwater. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the electrical or control system that has been
underwater.
PLEASE READ THESE INSTRUCTIONS PRIOR TO INSTALLATION, INITIAL FIRING, AND BEFORE
PERFORMING ANY SERVICE OR MAINTENANCE. THESE INSTRUCTIONS MUST BE LEFT WITH THE USER
AND SHOULD BE RETAINED FOR FUTURE REFERENCE BY QUALIFIED SERVICE PERSONNEL.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
All installations and services must be performed by qualified service personnel. 2 : If you do not follow these instructions exactly, a fire or explosion may result causing personal injury, loss of life or property damage. : NEVER use gasoline or a mixture of oil and gasoline to start the burner or ...
All installations and services must be performed by qualified service personnel. 7 II. GENERAL INSTRUCTIONS AND CLEARANCES NOTE: READ THIS SECTION BEFORE STARTING INSTALLATION 1. The selection of a furnace heating capacity for a proposed installation should be based on a heat loss calculation made a...
All installations and services must be performed by qualified service personnel. 8 b. Non-combustible material: “...material that is not capable of being ignited and burned; such as material consisting entirely of, or a combination of, steel, iron, brick, concrete, slate, asbestos, glass, and plaste...