Thermo Pride OH5-85DXE - Manual
Thermo Pride OH5-85DXE – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – This furnace is not to be used as a construction heater.
- Page 3 – ii; TABLE OF CONTENTS
- Page 5 – Then, by following the dimensions listed below,; UNIT
- Page 6 – specified otherwise by the individual coil manufacturer.; highboy
- Page 7 – When cutting openings in the casing; DO NOT CUT ANY SUPPORTING; Fig. 6: Cutaway view of fan section of a typical highboy furnace.
- Page 9 – Do not place loose insulation around chamber sides and back .
- Page 10 – RIELLO BURNER APPLICATION CHART; STAGE FIRING RATES; NOZZLE SIZE; HIGH FIRE
- Page 11 – WARNING: THE HEAT EXCHANGER MUST BE CLEANED BY A QUALIFIED; This panel is identified with a label.
- Page 12 – EXTERIOR OF FURNACE:; discoloration of materials and damage from rust or corrosion.; CHIMNEY OR VENTING SYSTEM:; The furnace venting system should be inspected for signs of rust,
- Page 13 – Fig. 18: Location of the air filter on the typical highboy furnace.
- Page 14 – CUSTOMER; COMBUSTION
- Page 15 – APPENDIX-A Replacement Parts List
- Page 16 – APPENDIX-B Wiring Diagram
MO-444
ECN 4673AMA
MADE IN USA
OIL FIRED FURNACE
INSTALLATION AND OPERATION MANUAL
WITH USERS INFORMATION SECTION
MODEL:
OH5-85DXE
c
WARNING
:
IF THE INFORMATION IN THESE INSTRUCTIONS IS NOT FOLLOWED EXACTLY, A FIRE
OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF
THIS OR ANY OTHER APPLIANCE.
c
WARNING:
IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE, OR MAINTENANCE
CAN CAUSE INJURY OR PROPERTY DAMAGE. REFER TO THIS MANUAL. FOR ASSISTANCE OR
ADDITIONAL INFORMATION CONSULT A QUALIFIED INSTALLER, OR SERVICE AGENCY.
PLEASE READ THESE INSTRUCTIONS PRIOR TO INSTALLATION, INITIAL FIRING, AND BEFORE
PERFORMING ANY SERVICE OR MAINTENANCE. THESE INSTRUCTIONS MUST BE LEFT WITH THE
USER AND SHOULD BE RETAINED FOR FUTURE REFERENCE BY QUALIFIED SERVICE PERSONNEL.
THERMO PRODUCTS, LLC.
PO
BOX
217
NORTH
JUDSON,
IN
46366
PHONE:
(574)
896-2133
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
i I. SAFETY SECTION This page contains various warnings and cautions found throughout the Oil Furnace Manual. Please read and comply with the statements below. c WARNING AND CAUTIONS: c WARNING: This furnace is not to be used as a construction heater. See Page 1. c CAUTION MUST BE TAKEN NOT TO EXCEE...
All installations and services must be performed by qualified service personnel. ii TABLE OF CONTENTS SECTION BEGINNING PAGE I. SAFETY SECTION i II. GENERAL INSTRUCTIONS 1 A. VENTING 2 B. DRAFT REGULATORS 2 C. DUCT WORK/AIR CONDITIONING 3 D. FILTERS MOUNTED EXTERNAL TO FURNACE 3 E. LIMIT POSITION AN...
All installations and services must be performed by qualified service personnel. 2 A. VENTING: NOTE: On the OH5-85DXE*** it is possible to rotate the flue elbow (which is factory installed for vertical discharge) 90° counterclockwise from the vertical position to adapt to various venting systems. c ...
