Star Trac Sep-90 - Manual
Star Trac Sep-90 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Training Manual; Components that connect to the display electronic:
- Page 3 – –The main keypad that is used to enter commands.; Center Console, Basic; –The small keypad that has the ‘Quick Start’ key. If the unit has any
- Page 4 – CSAFE Power; – The external CSAFE port.
- Page 5 – – The contact heart rate board plugs in
- Page 6 – – The small keypad at the top of the display housing.
- Page 7 – – The primary port for uploading
- Page 8 – – This is the main cable that connects the display to the LCB.
- Page 9 – L. HR Board Ground Cable –; connects to the display frame.
- Page 10 – Used for PVS and on “Made for iPod” kits only.
- Page 13 – This is where the LCB receives the signal from the RPM Sensor.
- Page 14 – Brings in the power from the alternator and controls the
- Page 15 – This is where the external CSAFE cable plugs in to the LCB for
- Page 16 – Software Uploading Connector (JP1 – 10 pin connector) –; This is used to load software into the LCB.
- Page 17 – Other Electrical Components; Conditions the input power (when using the external power supply).
- Page 18 – a. External Power Supply Port; communicate with the unit.; c. Coax Cable Connector –; embedded touch screen.
- Page 21 – C. Transmission Chain; – Connects the pedal drive to the main drive.
- Page 22 – Alternator and Drive Belt; Connects the alternator to the main drive.
Training Manual
STAR TRAC FITNESS
1 of 22
637-1376 Rev: A
Part Functionality
E-ST (Model 9-5090), LED Display
In this section, we will review all the components that make up the stepper. To resolve issues that may occur on an E
Series stepper, it is important to understand all the components and what function they play in the system.
1. Display Assembly (LED)
The display assembly is like the brains of the unit. It
controls and commands the stepper to take actions. It is the
user interface to control the machine. It also does the
following:
•
RPM calculations
•
Calorie calculations
•
Pre-designed programs
•
Heart rate calculation
Display
There are two main components to the display assembly:
Display Panel
Display Electronics
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Training Manual STAR TRAC FITNESS 2 of 22 637-1376 Rev: A Components that connect to the display electronic:
Training Manual STAR TRAC FITNESS 3 of 22 637-1376 Rev: A A. Display Panel (J7 – 12 pin connector) –The main keypad that is used to enter commands. B. Center Console, Basic (J8 – 6 pin connector) –The small keypad that has the ‘Quick Start’ key. If the unit has any kind of entertainment, there will ...
Training Manual STAR TRAC FITNESS 4 of 22 637-1376 Rev: A C. CSAFE Power (J10 – 6 pin connector) – The external CSAFE port. Note: This port is only used to supply power to external add on audio accessories. D. Polar Receiver (J11 – 3 pin connector) – The telemetry/wireless heart rate plugs in here (...
