Star Trac Sep-80 - Manual
Star Trac Sep-80 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Training Manual; Components that Connect to the Display Electronic:
- Page 3 – –The main keypad that is used to enter commands.; Center Console; entertainment, there will be extra keys for that.
- Page 4 – CSAFE Power
- Page 5 – E. Contact Heart Rate (6 Pin Connector on the standoff HR Board); – The contact heart rate board plugs in here. Note:
- Page 6 – – The small keypad at the top of the display housing.
- Page 7 – – The primary port for uploading
- Page 8 – – This is the main cable that connects the display to the LCB.
- Page 10 – Used for PVS and on ‘made for iPod’ kits only.
- Page 13 – with Upper Body Arm movement (Select Fit) need this connector.
- Page 14 – Supplies 12 Volts to the system.
- Page 15 – This is where the external C-Safe cable plugs in to the LCB.
- Page 16 – Brings in the power from the generator.
- Page 17 – resistance when the user wants that.
- Page 18 – B. Belt Tensioning Lever; both sides of the drive shaft.
- Page 19 – Leg Roller and Guide Rod; – They are exposed to a lot of load. Front to rear motion only.
Training Manual
STAR TRAC FITNESS
1 of 19
637-1377 Rev: A
Part Functionality
E-TBT (Model 9-6080) LED Display
In this section, we will review all the components that make up the E Series E-TBT (Total Body Trainer). To resolve issues
that may occur on an E-TBT, it is important to understand all the components and what function they play in the system.
1. Display Assembly (LED)
The display assembly is like the brains of the unit. It
controls and commands the TBT to take actions. It is the
user interface to control the machine. It also does the
following:
•
RPM Calculations
•
Calorie Calculations
•
Pre-designed Programs
•
Heart Rate Calculation
There are two main components to the display assembly:
Display Panel
Display Electronics
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Training Manual STAR TRAC FITNESS 2 of 19 637-1377 Rev: A Components that Connect to the Display Electronic:
Training Manual STAR TRAC FITNESS 3 of 19 637-1377 Rev: A A. Display Panel (J7 – 12 Pin Connector) –The main keypad that is used to enter commands. B. Center Console (J8 – 6 Pin Connector) –The small keypad that has the ‘Quick Start’ key. If the unit has any kind of entertainment, there will be extr...
Training Manual STAR TRAC FITNESS 4 of 19 637-1377 Rev: A C. CSAFE Power (J10 – 6 Pin Connector) – The external CSAFE port. Note: This port is only used for supplying power to external add on audio accessories. D. Polar Receiver (J11 – 3 Pin Connector) – The telemetry/wireless heart rate (signal sen...
