Smeg CMS4104G - User Manual

Page 7 - CONTENTS

7 CONTENTS INTRODUCTION ..................................................................... 8 Symbols used in these instructions ................................ 8Letters in brackets .......................................................... 8Troubleshooting and repairs ..............................

Page 8 - A25. Lighting knob to illuminate the interior compartment

8 INTRODUCTION Symbol used in these Instructions Important warnings are identified by these symbols. Failure to observe the Instructions for Use could result in electric shock, serious injury, burns, fire or damage to the appliance Danger! Failure to observe the warning may result in life threatenin...

Page 11 - off

11 Please note: To enable this function, the time must already be set correctly, see paragraph “Set time ”. To enable auto-start, proceed as follows:1. Press (B2) to enter the menu;2. Press (B10) or (B8) until the display (B) shows AUTO-START; 3. Select the function by pressing : The time setting pa...

Page 12 - Models with knobs; : it is possible to enables or disables; ting the coff

12 Light This function enables or disables the lights (A6). The cup lights (A18) come on each time coffee beverages are produced, hot milk is made and during each rinse cycle and turn off after a few seconds.To disable or enable this function, proceed as follows:1. Press (B2) to enter the menu;2. Pr...

Page 14 - er coff

14 preparation. If the coffee comes out too slowly or does not come out at all, a message will be shown GROUND TOO FINE. ADJUST GRIND LEVEL, turn the coffee mill dial one or two clicks clockwise. For fuller bodied creamier coffee, turn one click anticlockwise towards 1 (do not turn more than one cli...

Page 18 - Please note carefully:; The thermal casing must not be filled or immersed in wa-; Cleaning the hot water/steam connection nozzle

18 Cleaning the pre-gr ound coff ee funnel Check regularly (about once a month ) that the pre-ground coffee funnel (A21) is not blocked. If necessary, remove coffee deposits with the brush (C5) supplied. Cleaning the infuser The infuser must be cleaned at least once a month. Important! The infuser (...

Page 20 - Net weight: 20 kgg

20 Setting water hardness 1. Press (B2) to enter the menu; 2. Press (B10) or (B8) until the display (B) displays WATER HARDNESS ; 3. To change the level selected, press the symbol itself untilthe required level is displayed (Level 1 = soft water;Level 4 = very hard water); Press to go back to the ho...

Page 21 - DISPLAYED MESSAGES; DISPLAYED MESSAGE

21 DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY FILL WATER TANK WITH FRESH WATER Water in the tank (A12) is not sufficient. Fill the tank with water and/or insert it correctly, pushing it as far as it will go until it clicks into place. EMPTY GROUND CONTAINER The grounds container (A4)...

Page 25 - The inside of the appliance is very dirty.

25 DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY GENERAL ALARM: REFER TO USER MANUAL The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in section “Cleaning”. If the message is still displayed after cleaning, contact an authorised Customer Service centre....

Page 26 - TROUBLESHOOTING

26 PROBLEM POSSIBLE CAUSE REMEDY The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot water (Please note! the hot water function can be used). The infuser has cooled down because 2/3 minutes have elapsed since the last coffee was made. Before making the coffee, ...

Smeg CMS4104G - User Manual

Table of Contents:

Summary

Other Smeg Coffee Machines Models