Shop Fox W1888 - User Manual
Shop Fox W1888 Table Saw – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Model W1888
***IMPORTANT UPDATE***
Applies to Models Mfd. Since 10/20
and Owner's Manual Revised 10/20
Phone #: (360) 734-3482 • Tech Support: [email protected] • Web: www.woodstockint.com
We made the following changes to this machine since the manual was printed:
• Added push stick hangar.
• Revised inventory on
Page 17
and added steps to assembly on
Page 28
.
Aside from the information contained in this update, all other content in the owner's manual is
applicable and MUST be read and understood for your own safety.
IMPORTANT: Keep this update with the owner's manual for future reference
.
If you have any further
questions, contact our Technical Support.
READ THIS FIRST
Revised Inventory
Box Contents (see Figure 1)
Qty
Z.
Push Stick Hangar .........................................1
AA.
Hex Nuts
1
⁄
4
"-20 ...........................................2
AB.
Flat Washer 5mm ..........................................1
Figure 1.
Additional component inventory.
Z
AA
AB
Added Assembly Steps (Follows Step 33,
Page 28)
34.
Locate hole in cabinet near bottom left corner of
cabinet access door, then open door (see
Figure 35
).
35.
Thread (1)
1
⁄
4
"-20 hex nut with (1) 5mm flat washer
onto push stick hangar, secure with (1)
1
⁄
4
"-20 hex
nut (see
Figure 35
), then close door.
Figure 35.
Push stick hangar installed.
Cabinet
Access Door
COPYRIGHT © NOVEMBER, 2020 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in Taiwan
#21524BL
Push Stick
Hangar
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
