Shindaiwa 82010 - Manual
Shindaiwa 82010 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ASSEMBLY; the flattened end of handle brace,
- Page 4 – OPERATION
- Page 5 – order, and visually inspect their volume.
- Page 6 – RATE SETTING CONVERSION; 1RS settings when only the product weight,; some fines
- Page 7 – Oil the axle bearings, impeller shaft bearing
- Page 8 – Parts List for SHINDAIWA MODEL 41RS
OWNER’S MANUAL
TM
41RS
BROADCAST
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
ASSEMBLY Remove the spreader and com- 1. ponents from the carton. Turn spreader upside down. Insert (2) 1/4-20 x 1 1/2” hex bolts through the flattened end of handle brace, frame and leg as shown. Install hex nuts but do not tighten. Repeat on opposite side. Make sure braces are parallel and tighten...
OPERATION Check the product package for the rate 1. setting, and recommended swath width. Turn the spreader off by pushing the control knob in. Rotate the rate cam to the proper setting. Always fill the spreader on the driveway 2. or sidewalk-not on the lawn. Make sure spreader is in the “OFF” posit...
HOW TO DETERMINE SPREADER SETTINGS AND SPREAD WIDTH EFFECTIVE PATTERN WIDTH APPLICATION RATE Two major factors should be considered when determining correct spreader settings of any product: The product application rate, or the amount of material applied per 1,000 square feet. 1. The effective patte...
