Shindaiwa 81643 - Manual

Shindaiwa 81643

Shindaiwa 81643 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
Page: / 60

Table of Contents:

  • Page 2 – Introduction; Contents; Work Safely; Never allow a person without training or; Stay Alert; Safety Instructions; Never make unauthorized; Attention Statements
  • Page 4 – Be Aware of the Working Environment; FEET; IMPORTANT
  • Page 5 – Product Description; Prior to Assembly; Do not make unauthorized; Specifications
  • Page 6 – Handle; Assembly and Adjustments; Adjust Throttle Lever Free Play
  • Page 7 – Assembly; The unit should now be; Cutting Attachment Shield; Install the Cutting Attachment
  • Page 8 – The T242X should now be
  • Page 9 – Starting the Engine; Make sure; Mixing Fuel; Minimize the risk of fire!; Examples of 50:1 mixing quantities
  • Page 10 – OFF; Stopping the Engine; Idle Speed Adjustment
  • Page 11 – Edging; Cutting Grass—Units equipped with a trimmer head; Trimming and; Checking Unit Condition; Operation of trimmer without a; Engine Operating Speeds
  • Page 12 – OPERATE THE BRUSHCUTTER; Blade Thrust; never strike or; Vertical Cuts; only; Cut on the left
  • Page 13 – WARNING; General Maintenance; Muffler; Daily Maintenance; Prior to each work day, per form the following:; Every 10 hours of operation; not
  • Page 14 – Ever y 50 hours of operation; Ever y 10 to 15 hours of operation:
  • Page 15 – Ever y 135 hours of operation,; Never operate this trimmer
  • Page 16 – Shindaiwa Tornado
  • Page 17 – Troubleshooting Guide; ENGINE DOES NOT START; LOW POWER OUTPUT
  • Page 18 – ADDITIONAL PROBLEMS
  • Page 20 – Shindaiwa Corporation; NOTES
  • Page 21 – MANUAL DEL PROPIETARIO/OPERADOR SHINDAIWA; Disminuya el riesgo de sufrir lesiones
  • Page 22 – A travéz de este manual se encuentran; Toda información precedida por la palabra; especial y significante.; Trabaje con cuidado; Nunca permita que una persona sin; Mantengase alerta; verifique posibles pérdidas alrededor
  • Page 23 – Español; El Operario Debidamente Equipado; Instrucciones de Seguridad; más allá de lo especificado para
  • Page 24 – Etiquetas de Seguridad; Esté Alerta del Area de Trabajo
  • Page 25 – Descripción del Producto; Especificaciones; Antes de Ensamblar; No haga modificaciones o; PODADORA
  • Page 26 – Ensamblaje y Ajustes; Ajuste la holgura del acelerador; Mango
  • Page 27 – Protector del accesorio de corte; Instale el protector del accesorio; Pueda que sea necesario aflojar el retén y; instalado y asegurado firmemente.; Ensamblaje; La unidad debe ahora estar; Protector Secundario T242X.
  • Page 28 – Monte la cuchilla tipo.; su superficie impresa sea visible al; La T242X debe estar ahora
  • Page 29 – Arranque del Motor; el final de la cuerda. De lo contrario,; Mezcla de Combustible; Ejemplos de cantidades de; Nunca coloque material inflamable cerca
  • Page 30 – Cuando arranca el motor...; Parada del Motor; Ajuste de marcha mínima
  • Page 31 – Corte de Césped – Máquinas Equipadas con Cabezal de Corte; Consulte la figura 21.
  • Page 32 – Nunca golpee o choque un disco en; Corte en el lado
  • Page 33 – Mantenimiento General; Silenciador; Mantenimiento Diario; El usar repuestos no estándar podría; Mantenimiento Cada 10 Horas; Cada 10 horas de operación; No opere esta máquina si el filtro; Cuchillas; modificando su forma. Una vez; Antes de cada día de trabajo, efectúe lo siguiente:
  • Page 34 – Mantenimiento Cada 50 Horas; Cada 50 horas de operación; Cada 10 ó 15 horas de operación:; Mantenimiento Cada 10/15 Horas; La BPMR6A tambíen cumple con los; Retire y reemplace el
  • Page 35 – Cada 135 horas Mantenimiento; Nunca opere la máquina con un
  • Page 36 – Almacenamiento de Largo Plazo; Cada vez que la máquina no va a; Afilado de Discos; Disco Shindaiwa TornadoTM; Afile solamente los dientes de; Discos de dientes múltiples
  • Page 37 – Guia Diagnostico; EL MOTOR NO ARRANCA
  • Page 38 – PROBLEMAS ADICIONALES
  • Page 40 – NOTAS
  • Page 41 – MANUEL D’UTILISATION SHINDAIWA; Limiter tout risque de blessures, sur soi-
  • Page 42 – ançais; l’influence d’alcool, de drogues ou; Table des matières; Sécurité au travail; Ne jamais laisser le; Demeurer alerte; Mesures de sécurité; vérifier les fuites de; Mises en garde
  • Page 43 – excéder la longueur du fil
  • Page 44 – Tenir compte de l’environnement de travail; MÈTRES; Shindaiwa autorisé local.
  • Page 45 – Nomenclature; Avant l’assemblage; N’apporter de modifications non; Caractéristiques techniques
  • Page 46 – Poignée; Assemblage et réglage; Réglage du jeu du levier d’accélération
  • Page 47 – Tête de coupe; Assemblage; L’appareil doit maintenant être; Installation du déflecteur T242/; déflecteur
  • Page 48 – Le T242X doit maintenant être; La lame doit être fixée à plat
  • Page 49 – Démarrage du moteur; S’assurer que; Mélange de carburant; Exemples de quantités de
  • Page 50 – tourner lorsque le moteur démarre !; ARRÊTÉ; Arrêt du moteur; Réglage du ralenti; est au ralenti ! S’il est impossible de
  • Page 51 – Coupe d’herbe—Appareils équipés d’une tête de coupe
  • Page 52 – des fins autres que celles pour; Utilisation d’une lame T242X; deux dents ou de lame à quatre dents
  • Page 53 – immobiles. Débrancher le fil de la; Entretien; Silencieux; Entretien quotidien; Toutes les 10 heures d’utilisation; Ne jamais utiliser l’appareil si le filtre à; Lames; pas
  • Page 54 – Entretien aux 50 heures; Toutes les 50 heures d’utilisation; n’est pas percé par le fil crocheté. Le; Toutes les 10 à 15 heures de; l’aire autour de la bougie afin d’éviter; Entretien aux 10 à 15 heures; aux exigences en matière de conformité; Enlever et remplacer
  • Page 55 – Entretien aux 135 heures; Toutes les 135 heures d’utilisation,
  • Page 56 – Remisage à long terme; Lame Shindaiwa Tornado; couteaux; Lame circulaire à plusieurs
  • Page 57 – Guide de dépannage; LE MOTEUR NE DÉMARRE PAS; PUISSANCE INSUFFISANTE
  • Page 58 – AUTRES PROBLÈMES
Loading the manual

SHINDAIWA OWNER’S/OPERATOR’S MANUAL

T242 TRIMMER

T242X TRIMMER

WARNING!

Minimize the risk of injur y to yourself and

others! Read this manual and familiarize yourself with

the contents. Always wear eye and hearing protection

when operating this unit.

Part Number 81643 Rev. 1/07

T242

T242X

English.....................1

Español.............SP_1

Françias............FR_1

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Introduction; Contents; Work Safely; Never allow a person without training or; Stay Alert; Safety Instructions; Never make unauthorized; Attention Statements

The Shindaiwa 4 Series hand held power equipment has been designed and built to deliver superior per formance and reliability without compromise to quality, comfor t, safety or durability. Shindaiwa engines represent the leading edge of high-per formance engine technology, delivering exceptionally h...

Page 4 - Be Aware of the Working Environment; FEET; IMPORTANT

4 Be Aware of the Working Environment Avoid long-term operation in very hot or very cold weather. Make sure bystanders or observers outside the 50- foot “danger zone” wear eye protection. Be extremely careful of slippery terrain, especially during rainy weather. Always make sure the appropriate cutt...

Page 5 - Product Description; Prior to Assembly; Do not make unauthorized; Specifications

5 Product Description T4 dr y weight (less cutting attachment)........................................11.3 lb./5.1 kgT4X dr y weight (less cutting attachment)........................................11.9 lb./5.4 kgEngine model.......................................................................S4E ...

Other Shindaiwa Models

All Shindaiwa Other