Shindaiwa 80702 - Manual
Shindaiwa 80702 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Introduction; Prepare to Assemble; NOTES
- Page 3 – Shindaiwa Limited Warranty
- Page 4 – Changing Lever Operating Side; Part Number
- Page 5 – Calibrating the Sprayer; Typical Nozzle Assemblies
- Page 6 – Optional Accessories; Application; AVAILABLE SPRAY NOZZLES; Pump Disassembly; Maintenance; Troubleshooting: Lack of Pressure; CAUSE
SHINDAIWA OWNER’S/OPERATOR’S MANUAL
SP518 BACK PACK SPRAYER
䊛
Part Number 80702 Rev. 4/02
WARNING!
Minimize the risk of injury to
yourself and others! Read this
manual and familiarize yourself with
the contents. Always wear eye
protection, gloves and a respirator
when operating this unit.
䉸
Shindaiwa Inc.
11975 S.W. Herman Road
Tualatin, Oregon 97062
Telephone: 503 692-3070
Fax:
503 692-6696
www.shindaiwa.com
䊚
2002 Shindaiwa, Inc.
Part Number 80702
Revision 4/02
Shindaiwa is a registered trademark
of Shindaiwa, Inc.
Specifications subject to change without notice.
Printed in Brazil
䉸
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 This manual contains information for the proper assembly,operation and care of your SP518 sprayer. Carefully read andfollow the instructions contained in this manual before operat-ing your sprayer. Specifications Unpack the followingitems shipped inyour sprayer box: ■ Wand ■ Pump Lever andConnecti...
3 Connecting Rod Lever Washer Hitch Pin Install the Pump Lever andConnecting Rod Washer Washer Hitch Pin Pump Lever Shaft 1. Lightly grease the end of the pump lever connecting rod and insert into the upper hole in the pump lever. Securewith flat washer and hitch pin. 2. Install a flat washer on the...
4 1. Remove (2) hitch pins, washers and the pump lever from the base of the sprayer. 2. Remove the pump lever shaft and detach both shoulder straps at the base. 3. Install the pump lever shaft into the opposite hole in the sprayer base and insert the shaft retaining pin. 4. Remove the hitch pin, (2)...
