Shark ICZ362H - Manual - manualsarea.com

Page 2 - IMPORTANT SAFETY INSTRUCTIONS; FOR HOUSEHOLD USE ONLY; WHEN USING AN ELECTRICAL APPLIANCE, BASIC PRECAUTIONS SHOULD; WARNING; TO REDUCE THE RISK; READ ALL INSTRUCTIONS BEFORE; SAVE THESE INSTRUCTIONS; s h a r k c l e a n . c o m

IMPORTANT SAFETY INSTRUCTIONS FOR HOUSEHOLD USE ONLY WARNING WHEN USING AN ELECTRICAL APPLIANCE, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: To reduce the risk of shock and unintended operation, turn off power and remove the ION Power Pack battery before servicing. NOTE: If...

Page 3 - OUT OF VACU UM; IN CHARGING CR ADLE; Battery Runtime; SUCTION POWER MODES; ECO Mode; Deep Clean Mode; Boost Mode; SUCTION MODE

ASSEMBLY (Click) 1 (Click) 2 (Click) (Click) 4 3 (Click) (Click) 5 3 WAYS TO CHARGE THE LITHIUM-ION BATTERY OUT OF VACU UM IN CHARGING CR ADLE NOTE: Only one charger is provided. NOTE: When using the cradle, insert the charger plug into the port and rotate to lock into place. The battery will not ch...

Page 4 - Charging: One light flashes; FIRST AND THIRD INDICATOR LIGHTS FLASHING ALTERNATELY; Charge Indicator; CHARGE INDICATOR LIGHTS; OPERATING THE VACUUM; Wand Release; See next page for all the

Full Charge Nearly Full Mid Charge Low Charge Charging: One light flashes TEMPERATURE ISSUE: FIRST AND THIRD INDICATOR LIGHTS FLASHING ALTERNATELY NOTE: The battery must be charged before first use. A complete charge takes approximately 3.5 hours. NOTE: The indicator light will shut off 5 minutes af...

Page 5 - Dust Cup; UPRIGHT

MAINTENANCE EMPT YING THE DUST CUP To remove Dust Cup , slide up the release tabs on both sides. Tilt the dust cup away from pod, and lift to remove. To reinstall the dust cup, place the bottom into the pod and tilt the dust cup toward the wand until it clicks into place. Position the dust cup over ...

Page 6 - Replacement Pre-Motor Filter; MAINTENANCE

NOTE: To order replacement parts and filters, visit sharkclean.com . Replacement Pre-Motor Filter and Frame Replacement HEPA Post-Motor filter Rinse and replace the HEPA post-motor filter every year to maintain your vacuum's suction power.IMPORTANT: Rinse HEPA Post-Motor Filter with lukewarm water O...

Page 7 - Eject Roller; SOFT ROLLER; CLEANING OR REPLACING BRUSHROLLS; DO NOT; BRUSHROLL; TURN LOCKS

NOTE: To order replacement parts and filters, visit sharkclean.com . If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages or objects caught in the brushroll. 1. Turn off the vacuum. 2. Using a coin, turn locks counterclockwise to open, then lift off co...

Page 8 - ADDITIONAL ACCESSORIES; ACCESSORIES INCLUDED

A Crevice Tool B Multi-Surface Tool C Lithium-Ion Battery D Anti-Allergen Dust Brush E Charging Cord F Battery Charging Cradle A Flexi Crevice Tool B Upholstery Tool C Duster Crevice Tool D Under-Appliance Wand E Dusting Brush F Motorized Pet Tool (certain models only) G Wide Upholstery Tool H Car M...

Page 9 - LIGHT INDICATOR; BATTERY REMOVAL AND DISPOSAL; Part

TROUBLESHOOTING TROUBLESHOOTING Vacuum is not picking up debris. No suction or light suction. • Ensure handle, hose, dust cup, and wand are all securely connected. Detach and reattach until they all click securely into place. • Check filters to see if they need cleaning. Follow instructions for rins...

Page 11 - PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.

© 2022 SharkNinja Operating LLC. DUOCLEAN, LIFT-AWAY, POWERED LIFT-AWAY, SHARK, and VERTEX are registered trademarks of SharkNinja Operating LLC. POWERFINS is a trademark of SharkNinja Operating, LLC. ICZ362H_IB_E_REV_Mv12 PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE. This Owner’s Guide is de...

Shark ICZ362H - Manual

Table of Contents:

Other Manuals for Shark ICZ362H

Summary

Other Shark Vacuums Models