Scotsman SCN60GA1SU - User Manual

Location Recommendations: The machine can be built into a cabinet. It is an aircooled refrigeration system and so air flows in andout of it through the grill at the bottom front. Thegrill must not be blocked by any covering door orother obstruction. There are two models, one is a gravity drain typea...

Door Panel Attachment May 2011 Page 6 SCN60User's Manual Gasket ScotsmanDoor Panel Cover Machine Screw Use Upper Hole at the Top Use Lower Hole at the Bottom Hole Plug

Door Swing Note: Prior models had separate hinge bracketsand different directions to change swing. Moving the hinges allows the door to open fromeither the left or right side. Change swing beforeattaching door panel. To change: 1. Remove innermost screw holding each hingeto cabinet, loosen the other...

Plumbing - Pump Model Drains There are two types of ice machine models, onethat drains by gravity and one that has an internaldrain pump. Drain Pump Model drain installation 1. Locate the coil of 3/8” ID plastic drain tubingsecured to the back of the unit. 2. Route the plastic drain tube from the ba...

Plumbing: Gravity Drain Model Caution: Restrictions in the drain system to themachine will cause water to back up into the icestorage bin and melt the ice. Gravity drain tubingmust be vented, have no kinks and slope to thebuilding drain. Air gaps are typically required bylocal code. 1. Place the ice...

Electrical and Start Up The ice machine is supplied with a power cord. Donot remove the grounding pin from the cord’s plug.Do not use extension cords. Follow all codes. Connect the machine to its own properly grounded115 volt, 15 amp circuit. 1. If the electrical outlet for the ice maker is behindth...

Use No special instructions are needed for use. Justtake as much ice as you need, the machine willreplace it. A scoop is provided, and it can be storedin the machine using the loop of tubing on the rightside as a holder. The machine can be shut off anytime by justpushing and releasing the On/Off but...

Maintenance Scotsman strongly recommends regular maintenance of this ice machine. During normal operation mineral scale that is in the water supplywill gradually build up on the ice making surfaces.That build up can cause excessive loading of theice making system, which can cause prematurefailure. R...

How to remove scale from the ice making system. Cleaning this machine involves adding a solution of scale remover and water to the ice machine andcontinuing to add it as it makes ice. The scaleremover must be diluted to the correct ratio. Asquirt bottle will make adding the scale removermuch easier ...

11. Press and HOLD the both the Clean-Reset andOn/Off buttons for 5 seconds. The Time to Cleanlight will blink on and off. 12. The auger motor alone will be operating for 10minutes, after that the compressor will start and inabout 5-8 minutes the machine will start to makeice. The Time to Clean ligh...

What to do before calling for service Low capacity • Check for restricted drain or standing waterin the bin • Clean the air cooled condenser fins • Clean the ice making system No ice • Check on-off switch • Check electrical breaker • If the Check Water light is flashing Red,check water supply. The c...

17-3341-01 Rev. B SCOTSMAN ICE SYSTEMS 101Corporate Woods Parkway Vernon Hills, IL 60061 800-726-8762 www.scotsman-ice.com