Page 2 - IN TRO DUC TION; Stainless Steel Door Panel Kit is SS33
IN TRO DUC TION The Scotsman DCE33 is a restaurant type icemachine designed for home use. It produces thesame high quality ice as large Scotsmancommercial ice cube machines, and stores that ice in a heavily insulated storage bin. DCE33 User's Manual This service manual is intended as a resource forp...
Page 3 - CAB I NET DI MEN SIONS
CAB I NET DI MEN SIONS DCE33 User's Manual June 2013 Page 2 Overhead View of DCE33 and Companion Refrigerator Side By Refrig. IceMachine DCE33 Cabinet Views Pump Drain Hose is 3/8" ID Serial Number Tag Location Cool Air In Warm Air Out
Page 4 - IN STAL LA TION; The ice machine uses a fan to take in room air; built up mineral; Deionized water is not recommended.
IN STAL LA TION To properly make and store ice, the DCE33requires access to air, potable water, 115 voltelectricity and a drain. The machine must beinstalled indoors, in a controlled environment. Air: The ice machine uses a fan to take in room air at the front of the machine through the right side o...
Page 5 - TO IN STALL: Plumb ing; Installation Cautions:; Although the DCE33 has; Installations on a slab:; Use a pump; Installations over a crawl space or basement:
TO IN STALL: Plumb ing The water supply and drain should be roughed inand ready at the point of installation. A wall outletdirectly behind the ice machine will makeundercounter installation easier. All electrical,water and drain connections must conform to localcodes. Installation Cautions: Although...
Page 6 - FOLLOW ALL LOCAL PLUMBING CODES; Install a flare nut and flare the end of the tube.
TO IN STALL: Plumb ing Free Standing Cabinet, Gravity DrainModel: All horizontal runs of drain lines must have a 1/4"per foot fall. An air gap will likely be requiredbetween the ice machine drain tube and thedrain/waste receptacle. A stand pipe with a trapbelow it would be acceptable for the dra...
Page 7 - Remove the kickplate and control box cover.
TO IN STALL: Plumb ing Free Standing Cabinet, Pump Model: 1. Remove the kickplate and control box cover. 2. Route the water supply, which should be a 1/4"O.D. copper tube through the back of the cabinetto the front. 3. Install a flare nut and flare the end of the tube. 4. Flush the water line an...
Page 8 - Push ice machine into installed position.; ALL PLUMBING MUST MEET LOCAL CODES
TO IN STALL: Plumb ing Built In, Gravity Drain Model: The drain and inlet water tubes must be plumbedbefore connecting to the ice machine. All horizontal runs of drain lines must have a 1/4" per foot fall. An air gap will likely be required between the icemachine drain tube and the drain/wastere...
Page 9 - Remove kickplate and control box cover.
TO IN STALL: Plumb ing Built In Pump Model: 1. Place ice machine in front of installed location.Adjust leg levelers to approximately correctposition. 2. Remove kickplate and control box cover. 3. Route water inlet line from wall through icemachine to the front. 4. Locate coil of 3/8" ID plastic ...
Page 10 - TO IN STALL: Add On Kits; Customizing Door Panel:
TO IN STALL: Add On Kits Door Kit: The door may be modified to accept adecorator door panel. Customizing Door Panel: A custom door panel may be installed in front ofthe standard one. Any panel 14 3 4 " wide, 28 15 16 " high and 1 4 " thick or less at the edges may be used as a decorator ...
Page 11 - AF TER IN STAL LA TION - OP ER A TION; Final Check List; Initial Start Up; Fill out and mail the Warranty Registration.; What to expect from the DCE33; The ice cubes are tapered cylinders about 1
AF TER IN STAL LA TION - OP ER A TION Final Check List 1. Has the machine been properly uncrated, andhave all packing materials and tape been removedfrom inside the bin? 2. Have the installation instructions been followed,including connecting the machine to water, drainand electricity? 3. Has the ma...
Page 12 - AF TER IN STAL LA TION; Reversing Door Swing:
DCE33 User's Manual June 2013 Page 11 AF TER IN STAL LA TION Reversing Door Swing: The hinged side of the door may be reversed tothe other side if desired: The DCE33 was shipped with the door hinged atthe right. The door and hinges are designed forplacing the hinges on either the right or the leftsi...
Page 13 - COM PO NENT LO CA TION
COM PO NENT LO CA TION DCE33 User's Manual June 2013 Page 12 Reservoir Curtain Bin Thermostat Bracket Control Box Cover Kickplate Control Knob Door Gasket
Page 14 - MAIN TE NANCE AND CLEAN ING; What shouldn’t be done?; There are 5 things to keep clean:; How to clean the cabinet.; Winterizing; Drain pump models should have about; NOT
MAIN TE NANCE AND CLEAN ING What shouldn’t be done? Never keep anything in the ice storage bin that isnot ice; objects like wine or beer bottles are notonly unsanitary, but the labels may slip off and plug up the drain. Never allow the machine to operate without regular cleaning. The machine will la...
Page 15 - CLEAN ING; How to clean the ice making system.; that this does
CLEAN ING How to clean the ice making system. 1. Open the door andturn the ice machinecontrol knob to off. 2. Scoop out all of the ice, either discard it or saveit in a ice chest or cooler. 3. Pour 4 ounces of Scotsman Clear 1 Ice MachineCleaner (available from a local ScotsmanDistributor or Dealer)...
Page 16 - AD JUST MENTS
AD JUST MENTS There are three items that may be adjusted: CubeSize, Harvest Time, and Bin Level. Note: CubeSize and Harvest Time adjustments should only be done by a qualified service person. Cube size control. The cube size control should only be adjusted tobring the cubes to the correct shape, the...
Page 17 - Harvest Time Adjustment
Bin’s ice level. When the ice machine shuts off the ice level in thebin should be even with the metal tube inside thebin. If the ice in the bin is too high or low, turn theice machine control knob to adjust the binthermostat. 1. To lower the ice level, turn the knobcounterclockwise. Usually a 1/8 tu...
Page 18 - SER VICE DI AG NO SIS; PROBLEM; No water spray
SER VICE DI AG NO SIS DCE33 User's Manual J uly 201 8 Page 17 PROBLEM POSSIBLE CAUSE PROBABLE CORRECTION No ice falling in bin, but machineoperates Ice may be stuck in the evaporator and the unit is “frozen up”. Check water supply - filter may be restricted Check inlet water valve - screenmay be res...
Page 19 - WIR ING DI A GRAM
WIR ING DI A GRAM DCE33 User's Manual June 2013 Page 18
Page 20 - SCHE MATIC DI A GRAM
SCHE MATIC DI A GRAM DCE33 User's Manual June 2013 Page 19
Page 21 - SCOTSMAN ICE SYSTEMS; 01Corporate Woods Parkway
17-3354-01 Rev. B SCOTSMAN ICE SYSTEMS 101Corporate Woods Parkway Vernon Hills, IL 60061 800-726-8762 www.scotsman-ice.com