Schumacher PI-200 - Manual
Schumacher PI-200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – BEFORE USING YOUR POWER INVERTER
- Page 5 – Line filter capacitors; FASTENING THE INVERTER TO A FLAT SURFACE; For convenience, your inverter can be fastened to a flat surface,; CONNECTING INVERTER CABLES; Push the 12V power plug firmly into the outlet.
- Page 6 – Reverse these steps when finished using the USB port.; Using the inverter to operate a TV or audio device:; The inverter is shielded and filtered to minimize signal
- Page 8 – LED INDICATOR AND SHUTDOWN PROTECTION; slots or air flow over and through the inverter. Reduce the; IF THE INVERTER FUSE BLOWS; Your power inverter is fitted with a fuse, which should not have
- Page 11 – careless handling, repaired, or modified by anyone other than
- Page 12 – THIS LIMITED WARRANTY IS THE ONLY EXPRESS LIMITED; Schumacher; DO NOT RETURN THIS PRODUCT TO THE STORE!; Contact Customer Service for assistance:
- Page 13 – Schumacher Electric Corporation
- Page 14 – Visite nuestra página en
- Page 15 – un mensaje y una figura.
- Page 16 – potencial de gases inflamables o ropa.
- Page 17 – Por ningún motivo modifique el inversor, incluyendo cables,; ANTES DE USAR SU INVERSOR DE ENERGÍA; usted quiere usar es compatible con una onda senoidal modificada.
- Page 18 – Lámparas flourescentes y de alta intensidad (con balastra)
- Page 19 – Por comodidad, su inversor puede ser sujetado a una superficie; PARA CONECTAR LOS CABLES DEL INVERSOR; Empuje la clavija de 12V firmemente en la toma de corriente.; INSTRUCCIONES DE OPERACIÓN
- Page 21 – FUENTE DE ENERGÍA
- Page 22 – INDICADOR LED Y PROTECCIÓN DE DE APAGADO; siendo operado excede la clasificación de carga continua del
- Page 23 – SI SE QUEMA EL FUSIBLE DEL INVERSOR; al final de la clavija en el inversor.
- Page 25 – Verifique la posible; ESPECIFICACIONES; Onda Senoidal Modificada
- Page 27 – mal, se sujeta a manejo descuidado, se repara o modifica por; ESTA GARANTÍA LIMITADA ES LA ÚNICA GARANTÍA LIMITADA; ¡NO LO DEVUELVA ESTE PRODUCTO A LA TIENDA!; Contacte Servicios al Cliente para asistencia:
0099001323-00
Model/Modelo:
PI-200
Power Inverter
Converts 12V DC Battery Power
to 120V AC Household Power
Inversor de Energía
Convierte la Energía de Baterías
de 12V de CC a 120V de CA
de Energía Doméstica
OWNER’S MANUAL
MANUAL DEL USUARIO
READ THE ENTIRE MANUAL BEFORE USING THIS
PRODUCT. FAILURE TO DO SO COULD RESULT IN
SERIOUS INJURY OR DEATH.
LEA EL MANUAL COMPLETO ANTES DE UTILIZAR
ESTE PRODUCTO. CUALQUIER FALLA PODRÍA
RESULTAR EN SERIAS LESIONES O PODRÍA
SER MORTAL.
DO NOT RETURN THIS PRODUCT
TO THE STORE!
Contact Customer Service for assistance:
Phone: 800-621-5485
Email: [email protected]
Web: www.batterychargers.com
¡NO LO DEVUELVA ESTE PRODUCTO
A LA TIENDA!
Contacte Servicios al Cliente para asistencia:
Teléfono: 800-621-5485
Correo Electrónico: [email protected]
Sitio Red: www.batterychargers.com
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
• 3 • 1.3 Make sure the inverter is not close to any potential source of flammable fumes or clothing. 1.4 Do not place the inverter in areas such as battery compartments or engine compartments where fumes may accumulate. 1.5 Keep the inverter dry. 1.6 DO NOT allow the inverter to come into contact w...
• 5 • This inverter uses a nonsinusoidal waveform. Therefore, we do not recommend you use it to power the following devices: 1. Switch mode power supplies 2. Linear power supplies 3. Class 2 transformers 4. Line filter capacitors 5. Shaded pole motors 6. Fan motors 7. Microwave ovens 8. Fluorescent ...
• 6 • 5. OPERATING INSTRUCTIONS 1. Connect the inverter (see “CONNECTING INVERTER CABLES” section). 2. Make sure the device to be operated is turned OFF. 3. Plug the device into the inverter AC outlet. 4. Switch the inverter’s ON/OFF switch to the ON position. 5. Turn the device on. 6. To disconnect...
