Schumacher VTV-20 - Manual
Schumacher VTV-20 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – If the Working Vehicle’s Power LED light continually flashes
- Page 3 – has sufficient
- Page 4 – sufficient power
- Page 7 – LIMITEd WARRANTy
- Page 8 – NOTES
00-99-000720/06
Model: VTV-20
OPERATING INSTRUCTIONS
. Plug the short cable into the 2V accessory port of the vehicle
with the good battery. Wait for the Power and Status lights to
glow steadily.
2. The long cable plug should now be lit. Plug this end into the
accessory port of the disabled battery. If the connection to the
disabled battery is good, the plug and status light will blink.
If the light does not blink, check your connections. Also, try
turning the engine ignition key to the ACC position.
3. The plug will blink continuously. Try starting the vehicle after 5
to 0 minutes or if the plug stops blinking. If the vehicle does
not start, the plug will continue to blink.
4. If the vehicle does not start after 5 to 0 minutes of charging,
wait 5 additional minutes before trying again. When the 5
minute waiting period is up, try starting again.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 5. If the vehicle still does not start, repeat step 4. The VTV-20 will continue charging the battery for up to an hour. 6. If your vehicle does not start after an hour of charging, there may be other problems with the engine and/or starting sys- tem. It is also possible that the battery is incapab...
3 TROUBLESHOOTING PROBLEM CAUSE SOLUTION VTV-20 lights are not lit when plugged in Wrong end is plugged in Bad connection in the accessory port Accessory port does not have power Fuse in cables or car is blown Plug the short end into the good- battery vehicle’s accessory outlet Disconnect and reconn...
4 PROBLEM CAUSE SOLUTION Power light is blinking and status light is on The good battery does not have sufficient power (less than volts) The short cable has been plugged into the wrong vehicle Start the good- battery vehicle to provide extra power to the VTV-20 Make sure the short cable is plugged ...
