Sanus PFPL - Manual
Sanus PFPL – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – CAUTION; These loose items should be kept away from young children while
- Page 12 – Locking screw x8; Base
- Page 13 – Following steps apply to both flat and curved front designs.; Fasten the glides to the base as shown.
- Page 14 – is done, tighten all 4 Adjusting screws fully into Side.; Adjusting screw x 4
- Page 15 – Shelf Pin x8; for curved front design .; Glass shelf; Flat edge of the glass
Assembly Instructions
MODEL PFPL
-
Digital TV Stand
Congratulations and thank you for purchasing your new Sanus
Platinum Furniture Product. If you have any questions regarding
this or any other Sanus product, please contact our customer
service department at (800)359-5520, or www.sanus.com. It is
not necessary to contact the retailer with any questions or
problems, as parts can be sent directly to you
PLATINUM FURNITURE
BUS5305
BUS5305
We recommend that the unit is assembled on a soft surface
such as carpet. Please record your serial number in the space
provided below and retain this manual for future reference.
Serial No
Please follow these assembly instructions. This will save you
time, make assembly easier and prevent possible damage to
your new Digital TV Stand. Assistance may be required for
some assembly procedures. Correct assembly is your
responsibility.
This unit was manufactured using ISO 9000 certified systems.
For improvement purposes, design and specifications are subject to
change without notice.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Shelf Pin P840048 x 8 Cam P820015T x 8 Wooden dowel P800201 x 8 Connector rod P820016T x 8 P860121 x 1 P860015 x 8 P860035 x 6 Barrel nutP840050 x 8 P816145 x 4 Cable DuctsP840170 x 2 CAUTION There are many small components used in the construction of this unit. These loose items should be kept away...
Locking screw x8 Base 1. With assistance align Base onto Dowels in Sides & Rails & then press fit. 2. Fasten large Locking screws through Base into Sides & Rails ( Screw heads should be flush with surface ).
Glide x6 Screw x6 Following steps apply to both flat and curved front designs. 1. Fasten the glides to the base as shown.
