Prolux prolux_garage - User Manual

Page 2 - Contents

1 Contents Safety Instructions ---------------------------------------------------------------- 2-3 Included Parts -------------------------------------------------------------------- 3-4 Assembly Instructions ------------------------------------------------------------ 5 Operating Instructions ----...

Page 3 - Important Safeguards!

2 Important Safeguards! When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE Warning: To reduce the risk of fire, electric shock, or injury:  Do not use outdoors  Close supervision is necessary when any appl...

Page 4 - opening and moving parts.; Parts of the Vacuum

3  Keep hair, loose clothing, fingers, and all parts of body away from the opening and moving parts. Save these instructions! WARNING Operate cleaning system only at voltage specified on power unit. This system is intended for residential use. WARNING To reduce the risk of electric shock, this appl...

Page 6 - Mounting on drywall or plaster wall with stud (fasteners included); Locate a stud in your dry wall and drill a

5 Assembly Instructions 1. Remove the dirt tank by pulling up on both handles to unlatch. Lift upper half of unit to remove. 2. Remove all accessories and parts stored in the bottom of the tank prior to use. 3. If the round funnel comes out of dirt tank, set back inside the dirt tank before reassemb...

Page 7 - Mounting on concrete wall (fasteners included); sitting on the two hooks on the mounting bracket.; Mounting the Hose Holder (fasteners included); Determine desired location for hose holder

6 Mounting on concrete wall (fasteners included) You will need: (4) 3/8” x 2-1/4” concrete sleeve anchors. 1. Drill a 3/8” x 1-3/4” hole with a masonry drill bit. 2. Insert a bolt and anchor sleeve into the hole. 3. Align the bracket over the hole and mark the remaining hole locations using the (4) ...

Page 8 - Operating Instructions; Wet/dry vacuuming mode; “Know Your Product.”; Switch off immediately when the light turns red.

7 Hanging the Unit Hang your unit by putting the unit slots to the mounting bracket. Note: Make sure the unit fits securely on the mounting bracket and won’t fall down. Operating Instructions Wet/dry vacuuming mode 1. Plug in unit and locate the hose connector into the air inlet. See picture ‘A’ bel...

Page 9 - unplug the unit; and empty the water from the dust canister. (See

8 Solution: ① Empty the dust canister (See “Unit Cleaning” below) ② Clean the HEPA filter and cloth filter ( See “Unit Cleaning” below) The right indicator turns yellow when airflow is restricted, which can affect the “pick up” performance of the unit. Therefore, it is suitable to clean the dust can...

Page 10 - ‘A’ below. Attach extension wand, if

9 problem was because the copper pole was dirty and choked. The appliance should now be ok. If not, there are other problems and i t should be sent to repair. (See picture A) Vacuuming Liquids: a. After vacuuming liquids, keep the appliance running up to 3 minutes. Also, keep tubes on to eliminate a...

Page 11 - Using the Tools; Make sure the tools are secure to the hose or

10 2) A temperature protection device has been installed. W hen the temperatures exceed the rated limit, it will power off for protection. If this happens, clean filters and wait 30 minutes before reusing. 3) In the event of a clogged or full dirt tank, the yellow light will turn on indicating the d...

Page 12 - TOOL USE; Extension Wands

11 Auto Clean & Inflating: Water Extraction Suction tool. Precision blower tool for detailing Small, medium and large detailing and inflating tools. TOOL USE 11. 32ft Flexible Crush-Proof Hose – Connects to the vacuum on suction side or blow side. 12. Hose Holder – 32 ft hose can be neatly store...

Page 13 - HOW TO SHAMPOO UPHOLSTERY

12 20. Extraction Shampooer Suction Tool – used to vacuum up small wet spills and can also be used to shampoo your car interior (see shampooing section below). 21. 3 Sizes of Detailing & Inflator Tools – these 3 different sizes of inflator or blowing tools can be used to inflate mattresses or de...

Page 14 - Cleaning and Maintenance; C. Unscrew and take out the cloth filter

13 Cleaning and Maintenance Unit cleaning: Follow the steps below to get your HEPA filter, cloth filter and copper probe poles cleaned. A. Remove the dust bucket B. Take out the dirt tank and empty it. C. Unscrew and take out the cloth filter D. Unscrew and take out the HEPA filter E. Take out the c...

Page 15 - F: Wash the HEPA filter and cloth filter.

14 Filter Maintenance: From ordinary use the HEPA should be replaced once every year or when yellow light comes on (and dirt bin is clean). Replacing the HEPA filter does improve suction performance. Cleaning clogs: Low suction or poor pickup may be due to a clog in the vacuum. If this occurs, the L...

Page 16 - Troubleshooting; Limited suction power:; section “cleaning clogs” above in the owners manual as well as; Additional Parts that may be purchased from Prolux; Turbo Head for carpet cleaning -

15 Troubleshooting 1) Limited suction power: If you find the suction power is limited or not working to capacity, follow the steps below to fix: a. First check the dust tank. Clean the filter and empty the dust tank. b. After cleaning, if problem persist check for clogs. c. If problem continues and ...

Page 17 - Technical Data

16 Technical Data Motor Size 12 AMPS Rated voltage 120V Rated frequency 60Hz Power 107 CPM Color White Reservoir volume 5.3 Gallons Noise ≤72dB Unit Dimensions 32 x 35 x 80 CM

Prolux prolux_garage - User Manual

Table of Contents:

Summary

Other Prolux Vacuums Models