Polycom 70 - Manual
Polycom 70 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Installing the
- Page 4 – Before Installing; Warning; The 8-pin camera cable (labeled with the
- Page 5 – To remove the camera from the box:; Caution
- Page 6 – If the condition persists,
- Page 7 – not; inch
- Page 8 – To connect the camera cable:
- Page 9 – To connect an additional power cable:
- Page 10 – Specifications; Physical Specifications; NTSC or PAL
Installing the
iPower
™
70
Room Camera
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 About thisBooklet This booklet describes how to install the iPower ® 70 room camera. The iPower 70 is a pan-tilt-zoom (PTZ) camera that is used with a iPower collaboration system as a main or an auxiliary camera. This booklet contains information on: ❑ Before you install (page 4) ❑ Unpacking the b...
INSTALLING THE IPOWER 70 ROOM CAMERA 4 Before Installing Warning Before you begin this procedure, make sure you turn off your collaboration system’s power switch. To install this camera, you will need: ❑ The 8-pin camera cable (labeled with the icon on both cable collars) that came with your collabo...
Unpacking the Box 5 Unpacking theBox To remove the camera from the box: 1. With two hands, grasp the outside edges of the packing material and gently lift the unit from the box. 2. Carefully remove the camera from the packing material and place it on a flat surface. Caution When lifting the iPower 7...
