Philips MC151/05 - User Manual

4 EN 2 Your Micro Hi- Fi System Congratulations on your purchase, and welcome to Philips! To fully benefit from the suppor t that Philips offers, register your product at www.Philips.com/welcome. Introduction With this micro system, you can: • play audio from discs, tapes, and external audio devices...

5 EN Overview of the main unit c h ijkl m d e f g a b

8 EN 3 Get started Always follow the instructions in this chapter in sequence. Connect speakers Note • Inser t the stripped por tion of each speaker wire into the socket completely. • For better sound quality, use the supplied speakers only. • Connect only speakers with impedance that is the same or...

9 EN 3 Close the batter y compar tment. Note • Batteries contain chemical substances, so they should be disposed of properly. Set clock 1 Press POWER to switch the system to standby mode. » --:-- (or clock) is displayed. 2 Press and hold CLOCK/DISPLAY for 2 seconds to activate the clock setting mode...

10 EN 4 Play Play a disc Note • Make sure that the disc contains playable audio content. 1 On the top panel, pull up to open the disc compar tment. 2 Inser t a disc with the printed side facing up, then close the disc compar tment. 3 Press DISC to select the disc source. 4 Press to star t play. Cont...

11 EN Play a tape 1 Press TAPE to select the tape source. 2 On the front panel, pull at the PULL TO OPEN position to open the tape button cover. 3 Press to open the tape door. 4 Load a tape with the open side downward, and then close the tape door. 5 Press to star t play. • To pause or resume tape p...

12 EN 5 Listen to radio Tune to an FM/AM radio station Tip • For better reception, fully extend and adjust the position of the antenna. 1 Press TUN to select radio source. 2 Press and hold / until the frequency star ts to change. » [SEARCH] (search) is displayed. » The radio tunes to a station with ...

13 EN 6 Other features Set the alarm timer This micro system can be used as an alarm clock. You can select the disc or tuner as alarm source. Note • Make sure that you have set the clock correctly. 1 Press POWER to switch the system to standby mode. » The clock is displayed. 2 Press and hold TIMER f...

14 EN 7 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Output Power 2 x 2 W RMS Frequency Response 125 - 16000 Hz Signal to Noise Ratio 60 dBA Disc Laser Type Semiconductor Disc Diameter 12cm/8cm Suppor t Disc CD-DA, CD-R, CD- RW Fr...

16 EN 8 Troubleshooting Warning • Never remove the casing of this product. To keep the warranty valid, never tr y to repair the product yourself. If you encounter problems when using this device, check the following points before requesting ser vice. If the problem remains unsolved, go to the Philip...

17 EN 9 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Compliance This product complies with the radio interference requirements of the European Community. This apparatus includes thi...