Pelco TLR3096 - Manual

Pelco TLR3096

Pelco TLR3096 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
Page: / 76

Table of Contents:

  • Page 2 – CONTENTS; Section
  • Page 4 – LIST OF ILLUSTRATIONS; Figure; LIST OF TABLES; Table
  • Page 5 – WARNING; AVERTISSEMENT; CET APPAREIL À LA PLUIE NI À L’HUMIDITÉ.; GENERAL
  • Page 6 – The included
  • Page 9 – TLR3096 FEATURES AND FUNCTIONS; The battery backup
  • Page 10 – QUICK START; BASIC START; power; ADDITIONAL ITEMS; This section is
  • Page 11 – INSTALLATION; PRE-INSTALLATION CAUTIONS; If you need to record multiple cameras, a multiplexer is required.; Introduction To Time-Lapse Recorders; section for information on time-lapse recording.; SECURING THE VCR CONTROLS; Pelco recommends using a CCTV monitor.; Vertical Adjustment; section for
  • Page 12 – Remove the VCR and all cables from the box.; not; If you; are; using a switcher, refer to the; Connecting the VCR to a Multiplexer; Typical System Setup
  • Page 13 – CONNECTING THE VCR TO A MULTIPLEXER; Connecting VCR to Multiplexer; Figure 2 shows how to connect the VCR to an MX4000 Series Genex; For Automatic Speed Tracking; This is to start and stop recording when there are alarms.; Cameras and
  • Page 14 – ALARM RECORDING CONNECTION; Alarm Recording Connection; CONNECTING FOR SERIES RECORDING; Connecting VCRs for Series Recording; Connect the VCRs as shown in Figure 4. Refer to the; Series Recording; CONNECTING FOR REMOTE RECORDING; Connecting for Remote Recording; Connect the VCR with a remote switch as shown in Figure 5.
  • Page 15 – CONNECTING FOR SYNCHRONOUS RECORDING; Connecting for Synchronous Recording; CONNECTING FOR EXTERNAL TIME CLOCK ADJUSTMENT; Connecting for External Time Clock Adjustment
  • Page 16 – CONNECTING THE VCR TO A PC; VCR to PC Connection; Assigning; CONNECTING TO A PC FOR REMOTE CONTROL; Before
  • Page 17 – Cable Connections; FRAME
  • Page 18 – CONTROLS; FRONT PANEL; Front Panel; Insert the cassette in this slot to load it.
  • Page 20 – FLUORESCENT DISPLAY; Fluorescent Display; Lights during counter memory stop.; Daylight savings time indicator; Lights when DAYLIGHT SAVINGS is set to ON.; Repeat indicator
  • Page 22 – REAR PANEL; Rear View; The power cord plugs into this socket. Insert the cord firmly.; Series; Output Terminals; This is a special battery. Consult your dealer to; Jack for connecting a remote control unit.
  • Page 23 – JOG AND SHUTTLE CONTROLS; JOG Dial and SHUTTLE Ring; USING THE JOG DIAL; Turn by using your finger on the indent.; USING THE SHUTTLE RING
  • Page 24 – ADJUSTING THE CLOCK; Turn the SHUTTLE ring right. The VCR’s clock is now set.; ADJUSTING TO THE EXACT SECOND
  • Page 25 – PROGRAMMING; GENERAL PROGRAMMING INSTRUCTIONS; Language
  • Page 26 – QUICK GUIDE TO THE MENU STRUCTURE; Menu Tree
  • Page 27 – First Time Set Up Menu; Main Menu; Display Menu
  • Page 28 – TIMER PROGRAM MENU; Timer Program Illustration; Timer Recording; section for more detailed information; DW
  • Page 29 – RECORDING SET UP MENU; Refer to the; Programming for Alarm Recording; section for programming instructions for the; Recording Set
  • Page 30 – REAR TERMINAL; Rear Terminal
  • Page 31 – REC – During recording; REC IN; Sets the REC IN terminal’s operating mode.
  • Page 32 – MAINTENANCE MENU; Maintenance; FIRST TIME SET UP MENU; First Time Set
  • Page 33 – ADDITIONAL MATERIAL; DISPLAY MODE 1; Display Mode 1; Alarm recording counter
  • Page 34 – SET THE DAY AND TIME; If power goes out
  • Page 35 – LOADING, UNLOADING, PROTECTING THE TAPE CASSETTE; LOADING; CORRECT
  • Page 36 – UNLOADING; Press the EJECT button on the front of the VCR.; PREVENTING ACCIDENTAL ERASURE; Tape Replacement By Use; Number of Tape Uses
  • Page 37 – RECORDING; MANUAL RECORDING; Perform steps 3
  • Page 38 – RECORDING MODE; Table D shows recording times with T-120 and T-160 cassettes.; Recording/Playback Times; Recording Mode; RECORDING CHECK FUNCTION; Press the MENU button. The Main menu appears.
  • Page 39 – Action When Tape End is Reached by Setting; STOP; REPEAT; Same as above; ALARM•PROT; Recommended Number of Tape Uses; first VCR only; Series Recording 2; both
  • Page 40 – REMOTE RECORDING
  • Page 41 – SYNCHRONOUS RECORDING; Synchronous Recording Sequence; Recording Time Mode
  • Page 42 – Timer Program
  • Page 43 – HOLIDAY SET UP; SPECIAL DW SETTINGS; Adjusting the Clock
  • Page 44 – ALARM RECORDING; Recording Set Up Menu; Minimum Interval Between Recordings; Alarm Recording; VCR Switches to Alarm Mode
  • Page 45 – PROGRAMMING FOR ALARM RECORDING; until
  • Page 46 – RECORDING AFTER A POWER FAILURE; Power Loss List; MAINTENANCE; POWER LOSS LIST; without clearing
  • Page 48 – ELAPSED TIME AND REPEAT RECORDING TIMES DISPLAY; ELAPSED TIME; The number of tape uses is reset when a new tape is inserted.
  • Page 49 – PLAYBACK; PLAYBACK PROCEDURE; Playback Controls; Turn the JOG dial to select ON, and then turn the SHUTTLE ring right.; Playback Mode; Press STOP to halt playback.
  • Page 50 – Audio Playback and Picture Quality; END OF TAPE; End of Tape Actions; SPECIAL EFFECTS PLAYBACK
  • Page 51 – Shuttle Ring Speed Setting; DIRECT SHUTTLE RING; Direct Shuttle Ring Speed Settings
  • Page 52 – Tracking Adjustment; To adjust during playback:; ADJUSTING PICTURE QUALITY; Picture Quality Adjustment
  • Page 53 – Vertical Picture (Vibration) Adjustment
  • Page 54 – SEARCH TECHNIQUES; COUNTER MEMORY STOP; When the counter indicates 00000, COUNTER MEMORY STOP on the; SKIP SEARCH; Skip Search
  • Page 55 – INDEX SEARCH; To exit the Search Function menu without searching, press STOP.; HOW TO COUNT THE INDEX NUMBER; The maximum count of alarm recordings is; Index Searching
  • Page 56 – TIME AND DATE SEARCH; You can find a picture recorded at a specific date and time.
  • Page 57 – ADDITIONAL FUNCTIONS AND FEATURES; Counter Memory Stop; The backup is for
  • Page 58 – USING WITH A PC; Connecting the VCR to a PC; ASSIGNING THE RS-232C SETTINGS
  • Page 59 – Commands When Controlling One VCR; Example 1
  • Page 60 – WHEN CONTROLLING MULTIPLE VCRS; Commands When Controlling Multiple VCRs; Sending Commands
  • Page 61 – Example 2; Command for recording
  • Page 62 – COMMANDS AND RESPONSES CHART; The chart uses the following conventions:; Commands
  • Page 67 – out
  • Page 68 – ERROR CODES; Error; TESTING; INITIAL SYSTEM TESTING
  • Page 69 – TROUBLESHOOTING; SELF-DIAGNOSTIC FUNCTION AND WARNING DISPLAY; Warning Display and Actions
  • Page 70 – BEFORE CALLING FOR SERVICE; SYMPTOM
  • Page 72 – SPECIFICATIONS; ELECTRICAL
  • Page 73 – Tape Speed and Recording Time
  • Page 74 – INDEX; JOG dial operation 23
  • Page 76 – REVISION HISTORY; REGULATORY NOTICES; Reorient or relocate the receiving antenna.
Loading the manual

TLR3096

Time-Lapse VCR

Installation/

Operation Manual

C672M (2/01)

Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.com

In North America and Canada: Tel (800) 289-9100 or FAX (800) 289-9150

International Customers: Tel +1 (559) 292-1981 or FAX +1 (559) 348-1120

®

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - CONTENTS; Section

2 Pelco Manual C672M (2/01) CONTENTS Section Page GENERAL ............................................................................................................................. 5 SAFEGUARDS, WARNINGS, CAUTIONS, AND CARE ............................................... 6UNPACKING INSTRUCTIONS ....

Page 4 - LIST OF ILLUSTRATIONS; Figure; LIST OF TABLES; Table

4 Pelco Manual C672M (2/01) LIST OF ILLUSTRATIONS Figure Page 1 Typical System Setup ....................................................................................... 12 2 Connecting VCR to Multiplexer ......................................................................... 13 3 Alarm Recordi...

Page 5 - WARNING; AVERTISSEMENT; CET APPAREIL À LA PLUIE NI À L’HUMIDITÉ.; GENERAL

Pelco Manual C672M (2/01) 5 RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol,within an equilateral triangle...

Other Pelco Models

All Pelco Other