Pelco TI57 - Manual
Pelco TI57 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – : The camera mounting sled must be; BODY INSULATION INSTALLATION; sion of the enclosure.; LID INSULATION INSTALLATION; Unlatch the enclosure lid and raise.; Figure 1; . Lid and Body Insulation Sheets
- Page 3 – Figure 2; . TI57 Thermal Insulation Installation; When using blanking plates (in extreme cold; Lid
- Page 4 – (Product specifications subject to change
®
TI57 Thermal Insulation
for EH5700 Series Enclosures
Installation/Operation
Manual C1433M (6/95)
1.0 WARNINGS
Prior to installation and use of this product, the following
WARNINGS should be observed.
1.
Installation and servicing should only be done by
Qualified Service Personnel and conform to all
Local codes.
2.
Unless the unit is specifically marked as a NEMA
Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is
designed for indoor use only and it must not be
installed where exposed to rain and moisture.
3.
Only use replacement parts recommended by
PELCO.
4.
After replacement/repair of this unit’s electrical
components, conduct a resistance measurement
between line and exposed parts to verify the exposed
parts have not been connected to line circuitry.
2.0 SCOPE
The information contained in this manual covers the
TI57 Thermal Insulation Kit Installation.
2.1 DESCRIPTION
The TI57 Thermal Insulation Kit provides an improved
resistance to heat loss through the body of the enclosure
by adding a 1/4-inch thick polyurethane insulation to
the majority of the internal surfaces.
Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • (800) 289-9100 or (1-559) 292-1981
FAX (800) 289-9150 or (1-559) 292-3827
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 PELCO Manual C1433M (6/95) 3.0 TI57 THERMAL INSULATION NOTE : The camera mounting sled must be removed for proper installation of the thermalinsulation, therefore, it should be done prior tothe enclosure installation. (- 1, -2, -3; heater/blower/wiper kits must be removed prior to ther-mal insulat...
PELCO Manual C1433M (6/95) 3 Figure 2 . TI57 Thermal Insulation Installation NOTE: When using blanking plates (in extreme cold conditions), leave the vent/blanking plate area of theinsulation in place for extra protection. Lid Lid Insulation Body Insulation Body Assembly
4 PELCO Manual C1433M (6/95) 4.0 WARRANTY AND RETURN INFORMATION PELCO 3500 Pelco Way Clovis, CA 93612-5699 USA (559) 292-1981 • (800) 289-9100 FAX (800) 289-9150 or (559) 292-3827 International customers call 1-559-292-1981 or FAX 1-559-348-1120 (Product specifications subject to change without not...
