Pelco MLZ6DT - Manual
Pelco MLZ6DT – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – CONNECTOR ASSEMBLY; Contacts cannot be removed from the
- Page 4 – Wiring Diagram for Output Pin Assignments
- Page 5 – OPERATION AND SYSTEM TEST; AUTO operation only works in con-
- Page 6 – MLZ6DT Schematic
- Page 7 – MLZ6DT Dimension Drawing
- Page 8 – WARRANTY
®
1.0 WARNINGS
Prior to installation and use of this product, the following
WARNINGS should be observed.
1.
Installation and servicing should only be done by
Qualified Service Personnel and conform to all
Local codes.
2.
Unless the unit is specifically marked as a NEMA
Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is
designed for indoor use only and it must not be
installed where exposed to rain and moisture.
3.
The product bears the following marks:
Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • www.pelco.com
(800) 289-9100 or (1-559) 292-1981 • FAX (800) 289-9150 or (1-559) 292-3827
International customers call (1-559) 292-1981 or FAX (1-559) 348-1120
MLZ6DT
Motorized Zoom Lens Control
Installation/Operation Manual
C517M Rev C (6/92)
4.
Only use replacement parts recommended by Pelco.
5.
After replacement/repair of this unit’s electrial
components, conduct resistance measurements
between line and exposed parts to verify the exposed
parts have not been connected to line circuitry.
Please thoroughly familiarize yourself with the infor-
mation in this manual prior to installation and opera-
tion.
CAUTION:
TO REDUCED THE RISK OF ELECTRIAL SHOCK,
DO NOT REMOVE COVER. NO USER-SERVICE-
ABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
CAUTION:
RISH OF ELECTRIC SHOCK.
DO NOT OPEN.
This symbol indicates that there are
important operating and mainte-
nance instructions in the literature
accompanying this unit.
This symbol indiates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Pelco Manual C517M Rev C (6/92) 3 4.0 INSTALLATION 4.1 CONNECTOR ASSEMBLY Installation and/or testing will require you to assemblethe connector parts provided. Fabricate the intercon-necting cable according to the following steps (refer-ence Figure 1). 1. Slide part A of the cable clamp (item 1) ove...
4 Pelco Manual C517M Rev C (6/92) Figure 2. Wiring Diagram for Output Pin Assignments *NO CONNECTION REQUIRED EXCEPT WHEN USED WITH A1700. ALLOWS MANUAL IRIS CONTROL. CONTROL OUTPUT P3 LENS INPUT I R I S MANUAL IRIS* LENS COM ZOOM GND FOCUS RED BLUE BLK GRN WHT 10 2 13 12 8 11 1 5 4 2 G 3 YEL 1 3 12...
Pelco Manual C517M Rev C (6/92) 5 5.0 OPERATION AND SYSTEM TEST 1. Hook up the control cable between the output con-nector on MLZ6DT and the input connector on thelens (see Figure 3). 2. Check that the video is connected from the camerato the monitor. 3. Plug the mating connector of the wall mount t...
