Pelco L560 - Manual - manualsarea.com

Page 2 - CONTENTS

CONTENTS 1 - Introduction 2 - Safety Precautions 3 - Technical Information 4 - Unpacking and Installation Instructions 5 - Electrical Installation 6 - Operating Instructions 7 - Fault Finding 8 - Maintenance and Servicing 9 - Wiring Diagram & General Assembly 10 - Spare Parts List

Page 3 - conditions in both marine and land installations.

1 - Introduction It is imperative that this manual is read carefully and understood beforeinstalling your equipment. For your future reference please keep this manual ina safe place. Thank you for specifying a product from the Francis Searchlights range. All Francis products are designed to give com...

Page 4 - - Safety Precautions

2 - Safety Precautions The following instructions must be adhered to, in order to ensure a safe working environment andthe safety of the user. Note: When unpacking or manoeuvring the searchlight into its fixing position, suitable lifting points must be used in order to prevent damage to the equipmen...

Page 5 - - Technical Information

3 - Technical Information This product has been designed to operate in accordance with the product specification. TheL560RC searchlight has the following features: All marine grade materials and fixings; Parabolic formed aluminium reflector; Powder coated / Stove enamel paint finish; 385° ho...

Page 6 - - Unpacking and Installation Instructions; Safety Precautions

4 - Unpacking and Installation Instructions The following instructions should be read and fully understood prior to installing the equipment to ensure that the correct procedures are followed and all safety precautions are observed. Note: If the equipment has been in storage for a considerable amoun...

Page 7 - - Electrical Installation; Method of Electrical Connection; Disconnect the supply before working on the electrical system; connection and avoid any direct connection to the supply:

5 - Electrical Installation For safety purposes, only competent personnel should perform the electrical installation. Allequipment should be installed to current Electrical Regulations and Standards. In order to obtain the maximum light output from the searchlight, it is essential that the full oper...

Page 8 - Installation Guidelines; Cables required to be connected by the customer: -

Installation Guidelines A typical installation and connection routine for the L560RC 2/3Kw searchlight is as follows: Referring to wiring diagram C22978, a supply is fed to the control panel, which then provides acommon feed to the motor gearbox and the searchlight. Cables required to be connected b...

Page 9 - - Operating Instructions; Setting to Work

6 - Operating Instructions This equipment is designed for use out of doors, in free air. Never place anything on, or cover the searchlight when in use as this may present a hazard. The searchlight can be remotely positioned via the joystick control panel, with the facility for movement up, down, lef...

Page 10 - Testing

weaken the bulb material. Should the bulb be inadvertently touched, removefingerprints with methylated spirit and a clean, soft paper towel. The bulb should then be wiped with distilled water. NOTE: ALWAYS WEAR MASK AND GLOVES DURINGCLEANING); In all circumstances the lamp manufacturers data should ...

Page 11 - Fault Finding; Failure of Lamp to light; Failed lamp

7- Fault Finding All fault finding must be conducted by a competent person or qualified Electrical Engineer. Failure of Lamp to light Causes: 1) Power not supplied; 2) Fuse blown; 3) Failed lamp Remedy: 1) Check voltage at supply. If supply is not present the fault is at the customer supply. If powe...

Page 12 - - Maintenance and Servicing

8 - Maintenance and Servicing In order to prolong the service life and performance of your searchlight, the following maintenance guidelines are recommended: Maintenance checks should be conducted before very voyage or at least every three months; Before checking, disconnect the equipment from t...

Page 13 - - Wiring Diagram and General Assembly; Drawing Number; Wiring Diagram Lite Range Variable Speed 20 Amp

9 - Wiring Diagram and General Assembly Drawing Number Description C22978 Wiring Diagram Lite Range Variable Speed 20 Amp A2651 L560RC 2/3Kw 115/240v Variable Speed General Assembly drawing Control Panel Assembly

Page 17 - 0 - Spare Parts List; Part Number

10 - Spare Parts List The following spare parts can be ordered directly from the manufacturer: Part Number Description Searchlight Spares D1823 115v 2Kw G38 Tungsten Halogen Lamp D4604 220/240v 2Kw G38 Tungsten Halogen Lamp D9843 115v 3Kw G38 Tungsten Halogen Lamp D22559 220/240v 3Kw G38 Tungsten Ha...

Pelco L560 - Manual

Table of Contents:

Summary

Other Pelco Models