Pelco HK4220 - Manual
Pelco HK4220 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION; watts; Power Requirements and Recommended Cable Sizes; When using a
- Page 3 – Blower/Heater Kit Installation
- Page 4 – Endura and ExSite are trademarks of Pelco.; REVISION HISTORY; Date; SERVICE MANUAL; PRODUCT WARRANTY AND RETURN INFORMATION
C2415M (11/99)
BK4000 Series Blower Kit
HK4000 Series Heater Kit
®
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1.
Installation and servicing should only be done by qualified service personnel and conform
to all local codes.
2.
Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P
enclosure, it is designed for indoor use only and it must not be installed where exposed to
rain and moisture.
3.
Only use replacement par ts recommended by Pelco.
4.
After replacement/repair of this unit’s electrical components, conduct a resistance
measurement between line and exposed par ts to verify the exposed par ts have not been
connected to line circuitry.
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
3500 Pelco Way
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel +1 (559) 292-1981
FAX +1 (559) 348-1120
www.pelco.com
MODELS
BK4000 Blower kit for EH4014/EH4018 Series Enclosure, 120 VAC, 4 watts
BK4024 Same as BK4000 except for 24 VAC, 3 watts
BK4220 Same as BK4000 except for 230 VAC, 4.8 watts
HK4024 Heater kit, thermostatically controlled, 24 VAC, 40 watts, for EH4014/EH4018
Series Enclosure, activates ON at 40
°
F (4.44
°
C) and OFF at 60
°
F (15.56
°
C)
HK4220 Same as HK4024 except for 230 VAC, 30 watts
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INSTALLATION The following cable sizes are the minimum recommended for use with the combination ofblower/heater/camera. Power Model Number Input Voltage Consumption Cable Size Cable Distance EH4014-1/ 120 VAC 44 watts 22 AWG 1,013 ft (308.8 m) EH4018-1 20 AWG 1,612 ft (491.3 m) 18 AWG 2,564 ft (781....
Blower Kit If you are installing the blower kit in conjunction with a heater kit, skip this section and refer toBlower and Heater Kits (Dual Installation). To install a blower kit, perform the following steps: 1. Attach the blower assembly onto the bracket at the rear of the camera sled using thehar...
Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. ©Copyright 1999, Pelco. Endura and ExSite are trademarks of Pelco. All rights reserved. REVISION HISTORY Manual # Date Comments C2415M 11/99 Original version. SERVICE MANUAL If you need to order...
