Pelco DA104DT/220 - Manual
Pelco DA104DT/220 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION
- Page 3 – ELECTRICAL
- Page 4 – REVISION HISTORY; Date; Removed agency logos updated warranty and return information.; REGULATORY NOTICES; Reorient or relocate the receiving antenna.; WARRANTY AND RETURN INFORMATION
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1.
Installation and servicing should only be done by qualified service personnel and conform
to all local codes.
2.
Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P
enclosure, it is designed for indoor use only and it must not be installed where exposed to
rain and moisture.
3.
Only use replacement par ts recommended by Pelco.
4.
After replacement/repair of this unit’s electrical components, conduct a resistance
measurement between line and exposed par ts to verify the exposed par ts have not been
connected to line circuitry.
The product and/or manual may bear the following marks:
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
C605M-C (10/04)
DA104DT
Distribution Amplifier
3500 Pelco Way
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel (1-559) 292-1981
FAX (1-559) 348-1120
www.pelco.com
®
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
impor tant operating and maintenance
instructions in the literature accompa-
nying this unit.
C A U T I O N :
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
DESCRIPTION
The DA104DT Distribution Amplifier provides four independent video outputs from a single
video input. Solid-state circuitry consisting of four identical video amplifiers in parallel provide
four equal 75 ohm loads, which allow the video outputs to be viewed without distortion or loss
of clarity.
The DA104DT is available as a desk top unit; up to three units can be rack mounted using the
R300 Rack Mount Kit. (Blank filler panels are provided for fewer than three modules.) Two units
can also be mounted side-by-side in a single desktop chassis using the DT200.
MODELS
DA104DT
Distribution amplifier (1 input, 4 outputs), 120 VAC input.
DA104DT/220
Same as DA104DT except 230 VAC input.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Figure 1. DA104DT 120 VAC Input Diagram INSTALLATION Plug power cord into a 120 VAC, 60 Hz or 230 VAC, 50 Hz source depending on model ordered.Connect the input to a video camera with 75 ohm coax cable. Each output is capable ofsupplying video to more than one monitor. If more than one monitor is us...
OPERATION Turn the power switch on; a panel lamp will indicate that the unit is on. There are no adjustments necessary for proper operation of this unit. MAINTENANCE The DA104DT requires no periodic maintenance. In the event of any apparent amplifier failure,check all cables and connectors first. Be...
REVISION HISTORY Manual # Date Comments C605M-C 6/99 Original version. C605M-C 10/04 Removed agency logos; updated warranty and return information. REGULATORY NOTICES This equipment has been tested and found to comply with the limits of a Class B digitaldevice, pursuant to par t 15 of the FCC rules....
