Pelco C2928M-QS (7/05) - Manual

Page 2 - BEFORE YOU BEGIN; DOCUMENTATION

2 C2928M-QS (7/05) This quick start guide describes basic assembly and operation of the PMCD750 DLP ™ display as a stand-alone unit and as part of a video wall. BEFORE YOU BEGIN DOCUMENTATION Refer to the enclosed CD for the following documentation: • Installation/Operation manual • Copy of this Qui...

Page 3 - Chassis Assembly; SINGLE DISPLAY

C2928M-QS (7/05) 3 Chassis Assembly Unpack the PMCD750 unit. The screen is not needed yet and should be left in its container at this time. SINGLE DISPLAY Attach the screen support to the front edge of the chassis with the supplied screen support bolts. The screen support mounts only one way. It inc...

Page 4 - WALL DISPLAY – SECOND ROW AND UP

4 C2928M-QS (7/05) WALL DISPLAY – SECOND ROW AND UP Figure 2. Tie-Back Connection Points DANGER: Because the PMCD750 unit has a narrow front-to-back profile, the danger of tipping exists with high walls. For walls over two units high and all tilted walls, use the four tie-back points (1/4-20 threade...

Page 8 - Connecting Analog and Digital Sources

8 C2928M-QS (7/05) Connecting Analog and Digital Sources The PMCD750 will accept video input from devices with VGA or DVI output. Video sources with either or both of these output types can have their images displayed on the PMCD750. Refer to Figure 6. Figure 6. Video Input Connections Connect the v...

Page 10 - Installing Screens

10 C2928M-QS (7/05) Installing Screens To install a screen on a stand-alone unit, follow the instructions in steps 1a, 1b, and 1c. 1. To install the PMCD750 screens, start in the middle of the bottom row and install that screen. The screen supports should be installed on the bottom row of PMCD750 sc...

Page 12 - Connecting Power

12 C2928M-QS (7/05) Connecting Power 1. Bring AC power next to the electronics module. Connect the power to the receptacle located on the rear panel. The voltage can be 115 VAC (90–132 VAC) or 230 VAC (200–254 VAC). Refer to Figure 10. Figure 10. Power Switch and Receptacles 2. The AC power can be l...

Page 13 - Using The Remote Control

C2928M-QS (7/05) 13 Using The Remote Control Using the the remote control is the only way to access menu settings. There are no access controls on the display unit. The remote control projects a series of IR (infrared) pulses to the PMCD750 display for control. Aim the remote control at a single dis...

Page 14 - Alignment and Adjustment

14 C2928M-QS (7/05) Alignment and Adjustment If the image on the screen is not positioned accurately, alignment of the optical engine may be required. It is important to check this mechanical adjustment of the optical engine before any electronic adjustments are made to the picture. Refer to the Ali...

Page 15 - PRODUCT WARRANTY AND RETURN INFORMATION

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material orworkmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic ...

Pelco C2928M-QS (7/05) - Manual

Table of Contents:

Summary

Other Pelco Models