Pelco c2626M - Manual

6 C2626M (2/07) Product Overview DESCRIPTION The SX8205R unmanaged Ethernet switch provides five 10BASE-T/100BASE-TX ports for the transport of bidirectional Ethernet data. Operating as a single switch in a network, the SX8205R module connects to up to five 10BASE-T/100BASE-TX Ethernet devices. If a...

C2626M (2/07) 7 • Compliant with IEEE 802.3, 802.3u, and 802.3x standards • 10BASE-T/100BASE-TX compatibility with all Pelco ® and third-party 10BASE-T/100BASE-TX Ethernet devices • Environmentally hardened • Designed to meet NEMA TS 2 and Caltrans traffic signal control equipment standards for ambi...

8 C2626M (2/07) FRONT PANEL Figure 2 illustrates the front panel of the SX8205R module. Figure 2. Front Panel of SX8205R Module ì Reset Button: Restarts the unit î Power LED: Pelco badge NOTE: For additional information about the Power LED, refer to Troubleshooting on page 15.

C2626M (2/07) 9 REAR PANEL Figure 3 illustrates the rear panel of the SX8205R module. Figure 3. Rear Panel of SX8205R Module For additional information about rear-panel connections, refer to Installation on page 10. For detailed information about the RJ-45 LEDs, refer to Troubleshooting on page 15. ...

10 C2626M (2/07) Installation PACKAGE CONTENTS The following items are supplied: 1 SX8205R module 1 Regulated switching power supply with four plug adapters (North American, Australian, U.K., and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output 1 Wall clip with two 4-40 x 0.250-i...

12 C2626M (2/07) NOTE: TX Mode configuration must be set when the module is powered off. If you wish to change a TX Mode switch setting after the module has been powered on, power off the module, change the TX Mode switch setting, and then power on the module again. MOUNTING The SX8205R module can b...

C2626M (2/07) 13 Mounting the SX8205R Module Using the Wall Clip NOTE: Before mounting the SX8205R module to a wall, ensure that there is adequate space at both ends for viewing the front-panel Power LED and for making the various rear-panel cable connections. To attach the SX8205R module to a wall ...

C2626M (2/07) 15 Troubleshooting LED indicators on the front and rear panels of the SX8205R module allow you to monitor operational status: • The Power LED (Pelco badge) on the front panel (refer to Figure 2) allows you to monitor operating power. Refer to Table B for information about the Power LED...

C2626M (2/07) 21 Specifications PERFORMANCE Switch Type Unmanaged Layer 2 Switch Method Store and forward Switch Fabric Non-head-of-line blocking Data Rate 10/100 Mbps Compliance IEEE 802.3, 802.3u, 802.3x Interface Auto MDI/MDI-X Operating Mode Full-duplex or half-duplex Address Table Size 1,024 MA...

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on fiber optic products and TW3...