Page 3 - CONTENTS; LIST OF ILLUSTRATIONS
Pelco Installation Manual C1487M-H (1/01) 3 CONTENTS Section Page IMPORTANT SAFEGUARDS AND WARNINGS .................................................................................................................... 4 INSTALLATION .......................................................................
Page 4 - IMPORTANT SAFEGUARDS AND WARNINGS; must not be installed where exposed to rain and moisture.; MEASURES DE SECURITE IMPORTANTES
4 Pelco Installation Manual C1487M-H (1/01) IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes. 2. Unless the unit ...
Page 5 - INSTALLATION; PENDANT MODELS
Pelco Installation Manual C1487M-H (1/01) 5 INSTALLATION The Spectra II™ dome and Spectra Lite™ dome shipping cartons contain three boxes. Inspect each box to make sure all parts arepresent. IN-CEILING MODELS Back Box 1 Back box 1 Parts bag 1 Conduit fitting 1 Safety chain bracket 1 Lock nut 1 Compa...
Page 6 - HARD CEILING INSTALLATION; PREPARE CEILING; b. Draw a circle on the ceiling using the compass tool and a; INSTALL THE BACK BOX; b. Turn the thumb screw and open the hinged door to the back; a. Locate the center point of the mounting location. Drill a hole in
6 Pelco Installation Manual C1487M-H (1/01) HARD CEILING INSTALLATION IN-CEILING MODELS STEP 1 - PREPARE CEILING b. Draw a circle on the ceiling using the compass tool and a pencil. Cut the circle out of the ceiling. STEP 2 - INSTALL THE BACK BOX a. Attach the conduit fitting, lock nut, and safety c...
Page 7 - shooting
Pelco Installation Manual C1487M-H (1/01) 7 STEP 3 - INSTALL DOME DRIVE a. Set the DIP switches for SW1 and SW2 on the bottom of the dome drive for the appropriate receiver address. Refer to thelabels on the dome drive or Tables C through E in the Appen-dix in the back of this manual. b. Daisy Chain...
Page 8 - SUSPENDED CEILING INSTALLATION; PREPARE CEILING TILE; c. Compress the spring clips on the back box and push it through
8 Pelco Installation Manual C1487M-H (1/01) SUSPENDED CEILING INSTALLATION IN-CEILING MODELS STEP 1 - PREPARE CEILING TILE NOTE: The ceiling tile cannot be thinner than 0.50-inch (1.27 cm) or thicker than 1.75-inches (4.45 cm). a. Remove the ceiling tile from the ceiling. Insert the compass tool (su...
Page 9 - INSTALL DOME DRIVE; INSTALL LOWER DOME
Pelco Installation Manual C1487M-H (1/01) 9 STEP 3 - INSTALL DOME DRIVE a. Set the DIP switches for SW1 and SW2 on the bottom of the dome drive for the appropriate receiver address. Refer to thelabels on the dome drive or Tables C through E in the Appen-dix in the back of this manual. b. Daisy Chain...
Page 10 - PENDANT-MOUNT INSTALLATION; a. Install the mount for the pendant dome. Refer to the instruc-; WIRE CIRCUIT BOARD; If the LED does not light, refer to the Trouble-
10 Pelco Installation Manual C1487M-H (1/01) PENDANT-MOUNT INSTALLATION PENDANT MODELS STEP 1 - MOUNT AND INSTALL THE BACK BOX NOTE: If installing outdoors make sure the installation is properly sealed to keep moisture out. a. Install the mount for the pendant dome. Refer to the instruc- tions suppl...
Page 12 - SURFACE-MOUNT INSTALLATION; a. Turn the thumbscrew and open the; PREPARE SURFACE AND INSTALL THE BACK BOX; If the LED does not light, refer to the
12 Pelco Installation Manual C1487M-H (1/01) SURFACE-MOUNT INSTALLATION PENDANT MODELS STEP 1 - REMOVE THE TOP PORTION OF THE BACK BOX a. Turn the thumbscrew and open the hinged door located inside the back box. b. Unscrew the three Phillips screws lo- cated underneath the hinged door. c. Remove the...
Page 14 - TROUBLESHOOTING; PROBLEM
14 Pelco Installation Manual C1487M-H (01/01) TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Check to see if the red LED on the circuitboard in the back box is lit. 1. The red LED is not lit . a. Fuse is bad. b. 24 VAC power source is not con- nected or back box is bad. 2. The red LED is lit . a. W...
Page 15 - APPENDIX; Video Coaxial Cable Wiring Distances
Pelco Installation Manual C1487M-H (01/01) 15 APPENDIX Table A. Video Coaxial Cable Wiring Distances Cable Type* Maximum Distance RG59/U 750 ft (229 m) RG6/U 1,000 ft (305 m) RG11/U 1,500 ft (457 m) * Minimum cable requirements: 75 ohms impedance. All-copper center conductor.95% braided copper shiel...
Page 19 - SPECIFICATIONS; MECHANICAL
Pelco Installation Manual C1487M-H (1/01) 19 SPECIFICATIONS MECHANICAL Construction Back box: Aluminum Dome drive: Aluminum, ABS plastic Lower dome: Acrylic Cable Entry In-Ceiling: .75-inch (1.91 cm) conduit fitting Pendant: Through 1.5-inch (3.81 cm) NPT pendant mount Pan Movement: 360 ° continuous...
Page 20 - SD5 Series Dimension Drawing; See Figure 1
20 Pelco Installation Manual C1487M-H (1/01) 6.60 (16.76) 5.25 (13.34) 3.25 (8.26) 7.25 (18.13) 8.25 (20.96) 5.90 (14.99) NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES. Figure 1. SD5 Series Dimension Drawing 5 . 9 0 ( 1 4 . 9 9 ) 1 0 . 9 0 ( 2 7 . 6 9 ) 6 . 7 5 ( 1 7 . 1 5 ) 8 ....
Page 22 - MONOCHROME
22 Pelco Installation Manual C1487M-H (1/01) Sensitivity Spectra II 16X: .05 lux at 1/2-second shutter speed 18X: .2 lux at 1/4-second shutter speed (color).013 lux at 1/4-second shutter speed (black & white) 22X: .07 lux at 1/1.5-second shutter speed Spectra Lite: 1 lux at f1.6 at signal level ...
Page 23 - CERTIFICATIONS AND REGULATORY NOTICES
Pelco Installation Manual C1487M-H (1/01) 23 Shutter Speed: Automatic (electronic iris)/manual EIA: 1/60-1/30,000 CCIR: 1/50-1/30,000 Iris Control: Automatic with manual override* Gain Control: Automatic with manual override* Video Output EIA: .714V ± .07V (100 IRE ± 10 IRE) CCIR: .7V ± .07V Signal ...
Page 24 - REVISION HISTORY; PRODUCT WARRANTY AND RETURN INFORMATION
REVISION HISTORY Manual # Date Comments C1487M 7/98 Original version. C1487M-A 11/98 Revised the manual to incorporate Spectra Lite material. Added material on CCIR and EIA monochrome cameras, and PALcolor camera. Revised material in Section 5.11.21.2, Programming Limit Stops. Revised Section 6.0, T...