Pelco C1420M-H - Manual
Pelco C1420M-H – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – Installation; MOUNTING
- Page 6 – MATING CONNECTOR ASSEMBLY; Control Cable
- Page 7 – RECHARGING THE ENCLOSURE; POWER CONNECTION; Operation
- Page 8 – DISASSEMBLY; RECHARGING AND REASSEMBLY
- Page 9 – Specifications; Electrical
- Page 10 – ENVIRONMENTAL
- Page 11 – PRODUCT WARRANTY AND RETURN INFORMATION
C1420M-H (1/07)
®
I N S T A L L A T I O N / O P E R A T I O N
EH8106L Legacy
®
Pressurized Enclosure
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
4 C1420M-H (1/07) Installation MOUNTING To attach the enclosure to the pan and tilt unit, perform the following installation steps. 1. Make sure the tilt shaft on the pan and tilt unit is near horizontal so that the connector in the tilt shaft is pointing upward. 2. Lift the housing over the pan and...
6 C1420M-H (1/07) MATING CONNECTOR ASSEMBLY To assemble the 16-pin mating connector, perform the following steps: 1. Discard the white plastic sleeve that is included with the connector assembly. Thread the cable through the compression nut/strain relief and connector shell. 2. Prepare the cabling b...
C1420M-H (1/07) 7 RECHARGING THE ENCLOSURE You may use your own charging equipment or Pelco’s EH8000RKIT to recharge the enclosure. If you are using your own equipment, adjust the regulator for an output pressure of 12 psi (83 kPa). If you are using the EH8000RKIT, it uses a regulator with a fixed, ...
