Pelco C1005M-G - Manual - manualsarea.com

Page 2 - GENERAL; UNPACKING INSTRUCTIONS; Unpack and inspect all parts carefully.; DESCRIPTION

2 C1005M-G (10/02) GENERAL UNPACKING INSTRUCTIONS Unpack and inspect all parts carefully. The following items are supplied: 1 ICI1000PIM Personality Interface Module 1 RJ-14 cable for Inter-Check ® and the DX2000 DVR 1 RJ-45 coupler for the DX2000 DVR DESCRIPTION The ICI1000PIM Personality Interface...

Page 3 - INSTALLATION; INSTALLATION FOR INTER-CHECK; Cable Modification

C1005M-G (10/02) 3 INSTALLATION NOTE: The information in this manual is for PIM software version 4.02 and above. INSTALLATION FOR INTER-CHECK Refer to the ICI1000S Inter-Check manual as you install the ICI1000PIM. 1. Configure DIP switch bank 1 on the PIM (refer to Configuring DIP Switch Bank 1 sect...

Page 4 - Configuration for Wiring ICI1000PIM Module

4 C1005M-G (10/02) Figure 2. Configuration for Wiring ICI1000PIM Module WHITE BLUE BLACK YELLOW RED GREEN WHITE BLUE BLACK YELLOW RED GREEN STRAIGHT-THROUGHPHONE CABLE TO INTER-CHECK UNIT USER-SUPPLIED CABLE, 18 AWG,SHIELDED WIRE IS SUGGESTED FROM ICI1000PIM

Page 5 - Pelco PIM; as the

C1005M-G (10/02) 5 INSTALLATION FOR DX2000 DVR AND DX2000DH DATA HUB Refer to Figure 3 and the DX2000 Digital Video Recorder Installation/Operation Manual (C690M) and DX2000DH Data HubManual (C698M) as you install the ICI1000PIM. 1. Configure DIP switch bank 1 (refer to the Configuring DIP Switch Ba...

Page 6 - ICI1000PIM Switch Locations; CONFIGURING DIP SWITCH BANK 1; Switch 1; already; Switch 3; CONFIGURING DIP SWITCH BANK 2; Refer to Figure 4 and Table B to set the switches in bank 2.

6 C1005M-G (10/02) Figure 4. ICI1000PIM Switch Locations 1 2 3 4 5 6 7 8 ON 1 2 3 4 5 6 7 8 REGISTER/INTERFACE I PUT N BANK 1 BANK 2 DATA POWER ON CONFIGURING DIP SWITCH BANK 1 The switches in this bank serve several purposes. Selections include polling or non-polling operation, PIM addressing, cloc...

Page 7 - PIM Address Settings for Switch Bank 1

C1005M-G (10/02) 7 Table A. PIM Address Settings for Switch Bank 1 + = OPEN (FLIP THE SWITCH DOWN) – = CLOSED (FLIP THE SWITCH UP) SWITCH # 45678 POLLING PIM ADDRESS (PIM #) – – – – – 1 – – – – + 2 – – – + – 3 – – – + + 4 – – + – – 5 – – + – + 6 – – + + – 7 – – + + + 8 – + – – – 9 – + – – + 10 – + –...

Page 8 - Cash Register/Interface Configurations; Register/Interface Type

8 C1005M-G (10/02) Table B. Cash Register/Interface Configurations + = OPEN (FLIP THE SWITCH DOWN) X = POLLING/NON-POLLING R = RECEIPT (Normally CLOSED = – ) – = CLOSED (FLIP THE SWITCH UP) – = POLLING – = JOURNAL + = NON-POLLING + = SELECT G = GRAPHICS (Normally CLOSED = – ) Register/Interface Type...

Page 10 - SPECIFICATIONS

10 C1005M-G (10/02) SPECIFICATIONS ELECTRICAL PowerInput Voltage: 120 VAC, 60 Hz to wall mounted transformer(5 VDC, 300 mA from transformer to ICI1000PIM) Connectors: One 16-pin interface connectorOne RJ-14 modular data connectorOne transformer power connector DIP Switches: Two eight-position DIP sw...

Page 11 - WARRANTY AND RETURN INFORMATION; REVISION HISTORY

C1005M-G (10/02) 11 WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material orworkmanship for a period of one year after the date of shipment. Exceptions to this warranty areas noted below: • Five years on Pelco manufactured...

Pelco C1005M-G - Manual

Table of Contents:

Summary

Other Pelco Models