Pelco 2 C2485M-A (1/05) - Manual
Pelco 2 C2485M-A (1/05) – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Welcome
- Page 4 – Preinstallation
- Page 6 – Site Installation
®
I N S T A L L A T I O N M A N U A L
Pressurized
Spectra III
™
Series
Fiber Optic Models
C2485M-A (1/05)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
C2485M-A (1/05) 3 Welcome Thank you for purchasing Pelco’s Pressurized Spectra III ™ Series dome system with feedthrough for fiber optic modules with an ST-type connector. Your new system provides ultimate protection of the camera optics and electronics from moisture, corrosive gases, and airborne c...
4 C2485M-A (1/05) Preinstallation 1 Install the fiber optic module: Open the hinged door to the back box by pushing the tab lock towards the wall of the unit and lifting the door open. Remove the plug from the 16-pin connector. Install the module in the 16-pin connector. Secure the module to the cir...
6 C2485M-A (1/05) Site Installation 1 Feed a fiber optic cable (not supplied) and the supplied wiring harness into the front of the mount and out the back of the mount. Connect the wires as required. Refer to Tables A, B, and C for cable and wiring information. Fasten the mount to the mounting surfa...
