Patton 2450 - Manual
Patton 2450 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARRANTY INFORMATION
- Page 3 – Figure 2. Close-up of DIP switches showing “ON” and “OFF” positions; OFF; Figure 1. Underside of Model 2450, showing location of DIP switches
- Page 4 – S1 SUMMARY TABLE
- Page 5 – straight through twisted pair cable between 19 and 26 AWG.; CONNECTING OVER PRIVATE TWISTED PAIR; crossover cable pinned according to the diagram below.; SIGNAL
- Page 6 – LED STATUS MONITORS; straight through cable. When constructing or; AC POWER CONNECTION; Figure 6. Front view of Model 2450; Modes
- Page 7 – Note: The above V.52 BER tests can be used independently of the
USER
MANUAL
MODEL 2450
56/64 Kbps, 4-Wire
DDS & Clear Channel
CSU/DSU
SALES OFFICE
(301) 975-1000
TECHNICAL SUPPORT
(301) 975-1007
http://www.patton.com
Part# 07M2450-B
Doc# 099051UB
Revised 3/12/97
C E R T I F I E D
An ISO-9001
Certified Company
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 2450 components to be free from defects, and will—at our option—repair or replace the productshould it fail within one year from the first date of shipment. This warranty is limited to defects in workmanship or materials, and does not co...
2.0 GENERAL INFORMATION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected by Patton's qualifiedtechnicians. If any questions or problems arise during installation oruse of this product, please do not hesitate to contact Patton ElectronicsTechn...
Switch S1-3: Circuit Assurance On dedicated circuits, the transmitter and the CTS output can be configured to go On only when a working communication circuit isestablished. If Circuit Assurance is used, enable it on only one end ofthe communication link. Circuit S1-3 Assurance Description On Enabled...
