Patton 1000RC - Manual
Patton 1000RC – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – The Model 1000RC generates and uses radio frequency energy,
- Page 3 – Figure 2. Orientation of interface card straps
- Page 4 – Figure 3. Summary of jumper settings, *indicates factory default; Strap; indicates factory default; Figure 5. Strap locations for both rear cards; Converter
- Page 5 – Figure 7. Model 1000R16P Rack Chassis with power supply; There are no user-serviceable parts in the
- Page 7 – Connection to ground is optional; LED STATUS MONITORS; Note: The 1000RC is a “hot swappable” card—it will not be; Figure 9. The Model 1000RC front panel, showing LED positions
- Page 8 – general guideline only.
- Page 9 – The Patton Model 1000RC rack system features interchangeable; Description
USER
MANUAL
MODEL 1000RC
Asynchronous Short
Range Modem:
Dual Rack Mount Card
SALES OFFICE
(301) 975-1000
TECHNICAL SUPPORT
(301) 975-1007
Part# 07M1000RC-B
Doc# 052011UB
Revised 4/30/96
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 1000RC components to be free from defects, and will—at our option—repair or replace the productshould it fail within one year from the first date of shipment. This warranty is limited to defects in workmanship or materials, and does not ...
2.0 GENERAL INFORMATION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and iswarranted for One Year parts and labor. If any questions or problemsarise during installation or use of this product, please do not hesitate tocontact P...
3.2 FRONT CARD CONFIGURATION The Model 1000RC contains two sets of configuration straps which allow you to set the function of “Carrier Detect” output. Since the Model1000RC contains two modems, each unit can be configured separately:Jumper 1 (JB1) controls Unit A, while Jumper 2 (JB2) controls Unit...
