Nilfisk ALTO STEREO TUBE PREAMP - Manual

Page 2 - SAFETY RELATED SYMBOLS; C A U T I O N; WARNING; Denotes the product is turned on.

1 SAFETY RELATED SYMBOLS C A U T I O N R I S K O F E L E C T R I C S H O C K D O N O T O P E N This symbol, wherever used, alertsyou to the presence of un-insulatedand dangerous voltages within theproduct enclosure. These are voltagesthat may be sufficient to constitute therisk of electric shock or ...

Page 3 - IMPORTANT SAFETY INSTRUCTIONS; Power Cord and Plug

2 Do not install this product near any directheat source.Do not block areas of ventilation. Failureto do so could result in fire.Keep product away from naked flames. IMPORTANT SAFETY INSTRUCTIONS Read these instructionsFollow all instructionsKeep these instructions. Do not discard.Heed all warnings....

Page 4 - Preface

Preface 3 Dear Customer, . Thank you very much. LTO AUDIO TEAM Thanks for choosing LTO Stereo Tube Preamplifier and thanks for choosing one of the results of LTO AUDIO TEAM job and researches. For our LTO AUDIO TEAM, music and sound are more than a job...are first of all passion and let us say...our...

Page 5 - TABLE OF CONTENT; a. Guidepost of The Front Panel; TECHNICAL SPECIFICATIONS

4 TABLE OF CONTENT 1. INTRODUCTION ............................................................................................5 2. FEATURE LIST ..............................................................................................5 3. CONTROL ELEMENTS ..........................................

Page 8 - a. Power Supply Connection; Please use the 18VAC AC/AC Adaptor provided by

3.2 The Rear Panel 7 - Drive (12 for CHANNEL 1 and 14for CHANNEL 2): a. Power Supply Connection Please use the 18VAC AC/AC Adaptor provided by LTO to connect your MICtube. Detail your can follow the illustration. 18VAC b. Analogue Inputs / Outputs The Output XLR Connector is servo balanced and opera...

Page 9 - onnection; a. Wiring Configuration; For XLR connector

4. INSTALLATION & CONNECTION: 4.1 Mains Connection - Please ensure that the LTO MICtube Stereo Microphone Preamplifier is connected to the correct supply voltage before operating this unit. - Only use the 18VAC AC/AC Adaptor provided by LTO. 4.2 Audio onnection C a. Wiring Configuration b. In Li...

Page 10 - Unbalanced

9 4.3 Rack Mounting 5. APPLICATIONS 5.1 The MICtube as icrophone reamplifier A M P Unbalanced Balanced Ti p R i n g S l e e v e Ti pR i n g S l e e v e Ti p S l e e v e Ti p S l e e v e Ti p S l e e v e C e n t e r C e n t e r C e n t r e S c r e e n S c r e e n S c r e e n 1 23 Ti p R i n g S l e e...

Page 11 - MICtube as

1 0 5.2 The MICtube as Direct-Injection ox (DI Box) A B When audio signals produced by instruments such as guitars, keyboards, etc. aretransported over long unbalanced lines, the transmission quality may be affected byHum or other interference signals included in the cable. So called DI Box are used...

Page 14 - WARRANTY REGISTRATION CARD; A brief description of the defect will be appreciated.; TERMS AND CONDITIONS

1 3 7. WARRANTY 1. WARRANTY REGISTRATION CARD To obtain Warranty Service, the buyer should first fill out and return the enclosed WarrantyRegistration Card within 10 days of the Purchase Date.All the information presented in this Warranty Registration Card gives the manufacturer abetter understandin...

Page 16 - manual without written permission is forbidden. Copyright; SE KAKU TECHNICAL GROUP LIMITED

N F 0 0 8 7 0 - 2 . 3 No. 1, Lane 17, Sec. 2, Han Shi West Road, Taichung 40151 Taiwan http://www.altoproaudio.com Tel: 886-4-22313737 email: [email protected] Fax: 886-4-22346757 c All rights reserved to ALTO. All features and content might be changed without prior notice. Any photocopy, transl...

Nilfisk ALTO STEREO TUBE PREAMP - Manual

Table of Contents:

Summary

Other Nilfisk ALTO Models