Nilfisk ALTO GHIBLI 16FX - Manuals

Page 2 - SAFETY RELATED SYMBOLS; IMPORTANT SAFETY INSTRUCTIONS

1 SAFETY RELATED SYMBOLS C A U T I O N R I S K O F E L E C T R I C S H O C K D O N O T O P E N This symbol, wherever used, alerts you to the pre-sence of un-insulated and dangerous voltages with-in the product enclosure. These are voltages thatmay be sufficient to constitute the risk of electricshoc...

Page 3 - TABLE OF CONTENTS; . SYSTEM BLOCK DIAGRAMS

TABLE OF CONTENTS 1. INTRODUCTION...........................................................................................................................................3 2. FEATURES......................................................................................................................

Page 5 - MAIN MIX LEVEL; LTO

4. CONTROL ELEMENTS 4 GHIBLI 16 1 2 3 1 2 3 1 2 3 1 2 3 HIGH 15KHz HIGH 15KHz CLIP CLIP CLIP CLIP 0dB 0dB 0dB 0dB -20 10 0 -10 GAIN GAIN GAIN GAIN AUX1 pre AUX1 pre AUX1 pre AUX1 pre AUX2 post AUX2 post AUX2 post AUX2 post PAN PAN PAN PAN LEVEL LEVEL LEVEL LEVEL MUTE MUTE MUTE MUTE LEFT RIGHT OPERAT...

Page 6 - F X

5 GHIBLI 16FX 1 2 3 1 2 3 1 2 3 1 2 3 HIGH 15KHz HIGH 15KHz CLIP CLIP CLIP CLIP 0dB 0dB 0dB 0dB -20 10 0 -10 GAIN GAIN GAIN GAIN AUX1 pre AUX1 pre AUX1 pre AUX1 pre AUX2 post AUX2 post AUX2 post AUX2 post PAN PAN PAN PAN LEVEL LEVEL LEVEL LEVEL MUTE MUTE MUTE MUTE LEFT RIGHT OPERATING CHON CHON CHON...

Page 7 - You shall never connect an unbalanced microphone to the XLR; MONO CHANNEL INSERT; THE TUBE SOUND COMPRESSOR SWITCH

4.1 THE MIC/LINE INPUT These are Channel 1 through Channel 4. You can connect balanced, lowimpedance microphones or a low level signal to the XLR socket. On the1/4" Line jack you can connect either a microphone or a line level instru- ment . Note: You shall never connect an unbalanced microphone...

Page 8 - be affected by the LEVEL control of that

4.6 CLIP LED/0dB LED The green LED illuminates when the signal overpasses the 0dB level,the red CLIP LED illuminates when the channel is going into overload.If the CLIP LED becomes permanently on, reduce the amount of gain.To have best signal-to-noise ratio set the gain so that the green 0dB LEDbeco...

Page 9 - - REVERB LEVEL CONTROL

1 V I B R A F L A N G E 2 F U N K Y 3 R O C K A B I L LY 4 B I G S TA G E 589 1 2 V I B R ATO 1 3 F L A N G E R 1 6 C H O R U S PEAK REVERB LEVEL 10 8 9 1 12 11 7 4 5 6 3 2 13 14 15 16 FX LEVEL PRESETS +10 - 8 +10 - 8 2 4 2 4 2 1 2 2 4.18 24 BIT DIGITAL EFFECTS (For GHIBLI 16FX Model only) - PRESETS...

Page 10 - LEFT; Used to connect the supplied 24V AC adapter, supplied by; POWER

BALANCED +4dBu BALANCED +4dBu RIGHT OUT LEFT OUT GHIBLI 16 F X 16-CHANNEL MIXING CONSOLEWITH DIGITAL EFFECTS PHONES CENTER & SURROUND OUT AUX2 OUT AUX1 OUT LTO R 3 4 3 0 3 1 3 2 3 3 4.24 CENTER & SURROUND OUT This is Center and Surround output of the mixer. You can pickup their signals using...

Page 11 - INSTALLATION AND CONNECTION; headroom and ideal dynamic range.

5. INSTALLATION AND CONNECTION Ok, you have got to this point and you are now in the position to successfully operate your GHIBLI 16(FX). However,we advise you to read carefully the following section to be the real master of your own mixer. Not paying enoughattention to the input signal level, to th...

Page 12 - -pin XLR Line Socket; SOME FINAL TIPS ON WIRING CONFIGURATION

11 Strain Clamp Sleeve Tip Ring Sleeve=Ground/Screen Ring=Return Signal Tip=Send Signal Use for Insert Points 1/4" Stereo (TRS) Jack Plug Strain Clamp Sleeve Tip Ring Sleeve=Ground/Screen Ring=Right Signal Tip=Left Signal Use for Headphone 1/4" Stereo (TRS) Jack Plug Strain Clamp Sleeve Tip ...

Page 14 - PRESET LIST FOR GHIBLI 16FX

6. PRESET LIST FOR GHIBLI 16FX Position 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Name Vibraflange Funky Rockabilly Bigstage Vibrato4 Vibrato3 Vibrato2 Vibrato1 Flanger4 Flanger3 Flanger2 Flanger1 Chorus4 Chorus3 Chorus2 Chorus1 Eff.1 Variat (REVERB) Spring Rev. Spring Rev. Tape Rev. Hall Rev. Base Rev...

Page 15 - SYSTEM BLOCK DIAGRAMS; MONO; GHIBLI

7. SYSTEM BLOCK DIAGRAMS 1 4 1 2 3 4 5 6 7 8 A B C D 8 7 6 5 4 3 2 1 D C B A MONO INPUT CHANNELS(1-4) 2 1 3 MIC IN +18V 3-BAND EQ 80 600Hz 5KHz 15K - +/-15db PA N PHANT O M LINE IN GAIN POWER LO (FREQ) HI AUX1 AUX2 LEVEL POST PRE MIC G AIN: 0~50dB LINEGAIN: + 30dB~-20dB 3c 5e 1a 4d 2b INSER T T R S ...

Page 17 - TECHNICAL SPECIFICATION; Mono input channels

1 6 8. TECHNICAL SPECIFICATION Mono input channels Microphone input 0dB to 50dB (MIC) unbalanced 0.007% at +4dBu, 1kHz, Bandwidth 60KHz -20dBu to +30dBu Stereo input channels +10dBu unbalanced 10Hz to 55kHz, +/3dB Equalization Hi shelving + 15dB @12kHz Mid bell + 15dB @600~5kHz Low shelving + 15dB @...

Page 19 - manual without written permission is forbidden. Copyright; SEIKAKU TECHNICAL GROUP LIMITED

N F 0 1 8 8 9 - 1 . 2 No. 1, Lane 17, Sec. 2, Han Shi West Road, Taichung 40151, Taiwan http://www.altoproaudio.com Tel: 886-4-22313737 email: [email protected] Fax: 886-4-22346757 c All rights reserved to ALTO. All features and content might be changed without prior notice. Any photocopy, trans...