Nilfisk ALTO American 12 - Manual
Nilfisk ALTO American 12 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Contents of this Book
- Page 3 – WARNING; OPERATOR SAFETY INSTRUCTIONS
- Page 4 – Disconnect the power supply before attempting
- Page 5 – Introduction and Machine Specifications; PART NUMBER
- Page 6 – 30V Electrical Connection Instructions; Extension Cords
- Page 7 – How to Transport the Machine
- Page 8 – How To Install The Abrasive
- Page 9 – NOTE
- Page 10 – How to Operate the Machine
- Page 12 – Figure 6
- Page 13 – Sanding Cuts and Sandpaper; Initial Cut; Grain
- Page 14 – Sander Adjustment Procedures; DANGER; To adjust the sanding pressure follow this procedure:; Drum Rates; Tighten belt and secure motor to chassis.
- Page 16 – Routine Maintenance; Wheels; Periodically check the drive belt tension.; Bearings; Idler pulley
- Page 17 – Troubleshooting
- Page 23 – Motor Parts Not Illustrated
- Page 25 – AMERICAN SANDERS TECHNOLOGY
- Page 27 – Chatter - Wave Prevention
- Page 29 – CLARKE TECHNOLOGY; European Locations
- Page 30 – AMERICAN SANDERS TECHNOLOGY U.S. WARRANTY; AMERICAN SANDERS TECHNOLOGY reserves the right to make
Form No. 78150C
6/01
AMERICAN SANDERS TECHNOLOGY
Printed in the U.S.A.
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your ALTO
machine could result in injury to you or to other personnel; damage to the machine or to other property
could occur as well. You must have training in the operation of this machine before using it. If
operator(s) cannot read this manual, have it explained fully before attempting to operate this
machine.
Si Ud. o sus operadores no pueden leer el Inglés, se hagan explicar este manual completamente
antes de tratar el manejo o servicio de esta máquina.
All directions given in this book are as seen from the operator’s position at the rear of the machine.
For new books write to: ALTO U.S. INC., 2100 Highway 265, Springdale, Arkansas 72764.
American
12
Operator's
Manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 2 AMERICAN SANDERS TECHNOLOGY - American 12 Floor Sander Owner's Manual Contents of this Book Operator Safety Instructions ......................................................... 3Introduction and Machine Specifications ....................................... 5230V Electrical Connection Instr...
AMERICAN SANDERS TECHNOLOGY -American 12 Floor Sander Operator's Manual Page 3 DANGER means: Severe bodily injury or death can occur to you or other personnel if the DANGER statements found on this machine or in this Owner's Manual are ignored or are not adhered to. Read and observe all DANGER state...
Page 4 AMERICAN SANDERS TECHNOLOGY - American 12 Floor Sander Owner's Manual DANGER : Electrocution could occur if the machine is used on a power circuit that repeatedly trips or isundersized. Have a licensed electrician check the fuse, circuit breaker or power supply. DANGER: Electrocution could oc...
