National Instruments NI PXIe-8106 - Manual
National Instruments NI PXIe-8106 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Removing Protective Screw Caps; Caution
- Page 3 – NI PXIe-8106 Controller Installed in a PXI Express Chassis; How to Remove the Controller from the PXI Chassis; Power OK
- Page 4 – Things to Try; System CMOS; manuals; What If I Cannot See the Video?; Advanced
INSTALLATION GUIDE
NI PXIe-8106
This document contains information about installing your NI PXIe-8106
controller in a PXI Express chassis. For complete configuration and
troubleshooting information (including information about BIOS setup,
adding RAM, etc.), refer to the
NI PXIe-8106 User Manual
. The manual is
in PDF format on the recovery CD included with your controller and on the
National Instruments Web site,
ni.com/manuals
.
Installing the NI PXIe-8106
This section contains general installation instructions for the
NI PXIe-8106. Consult your PXI chassis user manual for specific
instructions and warnings.
1.
Plug in your chassis before installing the NI PXIe-8106. The power
cord grounds the chassis and protects it from electrical damage while
you install the module. Make sure the chassis power is turned off.
In some National Instruments chassis, such as the NI PXIe-1062Q,
ensure that the power LED is off. For more information about chassis
power behavior, refer to the user manual for the specific chassis.
2.
Remove any panels blocking access to the system controller slot
(Slot 1) in the chassis.
3.
Touch the metal part of the chassis case to discharge any static
electricity that might be on your clothes or body.
4.
Remove the protective plastic covers from the four bracket-retaining
screws as shown in Figure 1.
5.
Make sure the injector/ejector handle is in its downward position.
Align the NI PXIe-8106 with the card guides on the top and bottom of
the system controller slot.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
NI PXIe-8106 Installation Guide 2 ni.com Figure 1. Removing Protective Screw Caps Caution Do not raise the injector/ejector handle as you insert the NI PXIe-8106. The module will not insert properly unless the handle is in its downward position so that it does not interfere with the injector rail on...
© National Instruments Corporation 3 NI PXIe-8106 Installation Guide Figure 2 shows an NI PXIe-8106 controller installed in the system controller slot of a National Instruments NI PXIe-1062Q chassis. You can place PXI-1 or PXI Express devices in other slots. Figure 2. NI PXIe-8106 Controller Install...
National Instruments, NI, ni.com, and LabVIEW are trademarks of National Instruments Corporation. Refer to the Terms of Use section on ni.com/legal for more information about National Instruments trademarks. Other product and company names mentioned herein are trademarks or trade names of their resp...
