National Instruments network module - Manual
National Instruments network module – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Panel Mount; Do not use spliced DIN
- Page 3 – CAUTION; DIN Rail Mount
- Page 4 – and install rail locks at each end.
- Page 5 – A. Align slots on module with guide rails on; Connect the Network Cables; UTP Cable
- Page 6 – Wire Power to Your FieldPoint System; A. Connect 11-30 VDC power supply leads to V and C terminals of the
- Page 8 – Connect to Field Devices; Either the self-powered
- Page 9 – Power Up Your FieldPoint System; POWER and READY LEDs Stay Lit
- Page 10 – Start»Programs»National Instruments FieldPoint»FieldPoint; B. Right-click on the FieldPoint icon and select; Add a comm resource to this
- Page 11 – Ethernet; as the; Type
- Page 13 – File»Save
- Page 14 – Configure I/O Modules; A. Right-click on the device name in FieldPoint Explorer and select
- Page 16 – Where to Go from Here
- Page 17 – EMC directive
- Page 18 – Mechanical Dimensions
FP-1600 FieldPoint Quick Start Guide
1
Install the Network Module
1
Panel Mount
DIN Rail Mount
A. Unlock rail clip.
A. Unlock rail clip.
·
Network Module
·
Mounting Hardware (DIN rail
or panel mount accessory)
·
Terminal Base(s)
·
I/O Module(s)
·
Power Supply
·
FieldPoint Software CD
·
Accessories: Ethernet cable,
screwdriver
What You Need to Get Set Up
fpoint cd.qxd 11/13/00 1:23 PM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
B. Hook lip on back of module onto top of DIN rail, press down, and snapinto place. B. Snap panel mount accessory (which you can order separately)onto module. Panel Mount DIN Rail Mount NOTE: Do not use spliced DIN rails. Use only a single DIN rail. C. Slide module into position and lock rail clip. ...
Install the Terminal Base(s) CAUTION : Terminal bases must be connected to the network module before applying power to the module. Do not connect or disconnect terminal bases while power is applied to the network module. 2 DIN Rail Mount A. Unlock rail clip. B. Press base onto rail. Panel Mount A. U...
DIN Rail Mount Panel Mount D. Repeat for each terminal base, up to nine for each network module inmost cases. You can use one ortwo extender cables (which you canorder separately) if your FieldPointbank is too long for your availablespace. E. Place protective cover on last base, and install rail loc...
